This vehicle has a 26 gallon gas tank.When I dropped it to possible repair an E-VAP leak I noted that that the top part of the E-VAP / vent connector that is on top & near the front of the tank was loose due to apparently a poor glue connection from the factory,of the 2 parts..ie the main part cemented into the tank & the top half that was glued to the bottom portion where the control diaphragm is a part of.Anyway I cleaned the parts which were along with the rubber "O" ring type of seal which seals these 2 parts when put together are ok but I need a very strong glue that will adhere to these nylon type of plastic parts.I have never found any glue that would stick solidly & permanently to nylon types of plastic.I had checked into maybe just getting a new tank for the customer but the cost for 26 gallon tank was astronomical..over $850.00 just for a tank no matter where I checked..Mopar or after market.The 34 gallon tank which Chrysler also uses was only less than half that price but this vehicle has the 26 gallon one so that is why I want to try to repair it.Some used ones I checked into all were rusted badly at the steel fuel pump hold down connector that is molded into the plastic tank so that would be a no go for used.Two questions... is there any glue that will glue nylon strongly & correctly so I could repair this part as to have no leaks due to E-VAP problems from a poor glue connection that would arise & two.... would the larger 34 gallon size tank work & bolt right up into the original spot without any mods? This truck is a 4 door short box unit. Thanks in advance to all who may reply.

Arthur Margotta
Owner/Technician
AJ.'s Ultralights, Automotive & Sport Vehicles
Thompson, Pennsylvania, USA