 Prev |
Professional Automotive Repair Technical Discussions for September 15, 2026 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2006 Buick Rendezvous CX 3.6L No crank Customer said she was driving and the fuel gauge went to empty and the mileage changed to error. When it waa turned off it would no longer crank. Scanned systems and it has a class 2 bus fault in all modules,.except the Bcm. Im a euro tech so not too famil... |
View | |
| 2011 Honda CR-V LX 2.4L Poor Idle Quality, MIL Lamp on VIN: JHLRE4H33B First time customer in, no history on vehicle. Got this older, higher mileage CRV in for a CEL diag with a bit of a rough run. Scan and got the P0171 fault. Found the MAF reading low at 1.6g/s and MAP reading high at 1.1v, lambda at 1.47 and the downstream... Trouble codes: P0171 (lean bank 1) |
View | |
| 2017 Honda Accord EX 2.4L Hesitation, MIL Lamp on VIN: 1HGCR2F30H Hopefully some honda experts can help me out with this one. It will barely accelerate and has a long crank every time. I replaced the high pressure pump already with no change. The low pressure I checked with a gauge, and it reads between 50 and 60PsI, but... Trouble codes: P0087 (Fuel pressure too low) |
View | |
| 1999 Jeep Grand Cherokee Laredo 4.0L Poor Idle Quality The engine runs a bit rough, sounds rich but tailpipe Not sooty, plugs were black so I replaced them. It revs up ok in neutral but driving it only goes 15 mph, fairly smoothly. Torquing it, it's rough like a misfire. I read the P0138 once,and I see s2 h... Trouble codes: P0138 (Downstream o2 sensor shorted to b) |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers | |
| 2010 Mercedes-Benz E350 3.5L front rotors VIN: WDDHF5GB4A so it is fixed and this is the first time i have ever seen this ..customer never gave us the name of people working on the car..it may have been him..whoever replaced the front pads and rotors and the rear pads installed the pad clips under the caliper body on... |
10 |
