 Prev |
Professional Automotive Repair Technical Discussions for April 8, 2020 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 2009 Ford Mustang 4.0L Cuts out, Stall, MIL Lamp on VIN: 1ZVHT80N79 I am struggling with this one. I have done a ton of these cars. The car had a seized cam and broken timing guides. The left head had three bent exhaust valves. All repairs completed. I am getting a P0320 Ignition distributor engine speed circuit fault. Ori... Trouble codes: P0320 |
View | |
| 2017 Ford F-250 Super Duty Lariat 6.2L No Start, Excessive cranking t VIN: 1FT7W2B64J Was not able to T into fuel supply. Read approx 62 psi. Pressure drops almost immediately to close to zero. Is there a check valve in the fuel pump too hold pressure koeo? Crank time most of the time is at least 5 seconds. Thanks |
View | |
| 2000 Mercury Sable LS Premium 3.0L No Start VIN: 1MEFM55S7Y Customer complains of "intermittent" extended crank.. Car had been in prior and I had been unable to duplicate the issue.. until now. the vehicle will crank extensively ( 20+ seconds ) before starting, or I will allow the key to rest, before re-crank... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2012 Ford Focus SE 2.0L Starter/Communication VIN: 1FAHP3F21C She's fixed and paid for! Lots of help here. Special thanks to Michael [...] for checking TCM history and open campaigns for me. My local dealer wouldn't even do that. They did tell me about warranty coverage. I had voltage drop tested lots of things, even... |
10 | |
| 2015 Ford F-150 XLT 2.7L cooling fan VIN: 1FTEX1EP7F I replaced both relays for the cooling fan on the right side and vehicle has been good for a week now. |
12 | |
| 2010 Lincoln MKS EcoBoost 3.5L Blower Motor VIN: 1LNHL9FT4A It ended up being something simple as it usually does. I back probed the connector at the speed controller to read the PWM signal. After I inserted the pin the blower functioned normally, removing the pin and wiggling the connector the blower would stop. I rem... |
4 |
