 Prev |
Professional Automotive Repair Technical Discussions for December 9, 2019 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2013 Hyundai Azera 3.3L 3-4 Shift VIN: KMHFH4JGEA The car caqme not moving we changed the trans and now we have almost the same problem with a second trans from lkq thsi second one had 40000 miles and slips badly in 3rd gear we flushed the lines and made sure the fluid level was ok we did a relearn severa... |
View | |
| 2010 Lexus RX450h 3.5L MIL Lamp on VIN: JTJBC1BA1A Vehicle was towed in. Cust says would not accelerate, MIL flashing, check Hybrid system & check all wheel drive displaying on dash. I cleared codes and drove vehicle, took about 1.7 miles then limp mode kicked in and barely limped back to shop, P0A78 retur... Trouble codes: P0A78, C1259 (HV system regen malf - stored in ABS), C1310 (Malf in HV system - stored in ABS) |
View | |
| 1995 Toyota Corolla DX 1.8L Gas smell VIN: 1NXAE09B7S Car came in for routine oil change. But I noticed a strong gas smell if I stood away from the vehicle. Customer never noticed because the smell is NOT inside the car. Cannot find any leaks with car running from below. Do not see any leaks from above fro... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2008 Honda Odyssey EX-L 3.5L Serpentine belt VIN: 5FNRL38758 Van is fixed! The tensioner HAD already been replaced before initial help request. AND the noise sounded identical after the replacement. There never was a de-coupler pulley from the dealer on this vehicle, and I decided not to try to change that. I replac... |
20 | |
| 2016 Honda Accord Touring 3.5L Surge VIN: 1HGCR3F84G Short answer- it was the transmission. Thanks to Steve [...] for giving me a different direction to look at. Steve's suggestion to unplug the front O2 sensors to put it in closed loop and Louis's suggestion to t... |
16 |
