
![]() |
Professional Automotive Repair Technical Discussions for May 3, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next ![]() |
(Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. |
Open Help Requests for Ford
Help Request | Answers | |
1991 Ford E-150 Econoline Custom 4.9L Engine Performance VIN: 1FTDE14Y7M The Van was towed in from another shop, complaint was Hesitation on acceleration . Distributor, Coil, wires and plugs were replaced. we thought how hard would it be to find the problem on a 91 Ford with 4.9L... my first steps were to check TPS, EGR, Inject... |
View | |
1997 Ford F-150 Lariat 4.6L abs VIN: 1FTDX1762V The brake pedal on this truck pulsates really bad. I have never encountered a brake pedal that travels about an inch or more as it pulsates. This truck has rear abs. I disconnected the differential speed sensor, test drove it and same issue. I disconnected... |
View | |
2008 Ford Crown Victoria 4.6L compressor VIN: 2FAFP71V88 I have this 2008 police car with no a.c. We started from scratch. reclaimed a.c. and charged to make sure it had the correct amount of R134. The a.c. relay has power on the control side and the amperage side but no ground from the computer to engage. I can... |
View | |
2009 Ford Flex Limited 3.5L brakes this car came in with a soft brake pedal on the first initial apply. Seems like it better once its pumped then after you wait a few minutes to apply again goes down quite a ways. I have blocked off all four wheels with no positive effect also have bled wit... |
View |
Fixes & Summaries for Ford
Fix/Summary | Answers | |
2008 Ford F-150 XLT 5.4L Power steering VIN: 1FTPW14558 First and foremost thank you to everyone who replied, looks like boss was right about it not needing a rack. We talked to the customer and prepared to do the rack replacement as a worst case scenario, and naturally checked the steering shaft u-joints as the fi... |
7 |