 Prev |
Professional Automotive Repair Technical Discussions for May 3, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2004 Honda Pilot EX 3.5L Abs 2004 Pilot, recent brakes including new rotors and caliper overhaul. Recently as the car comes within a few feet of stopping under normal to moderate braking the ABS kicks in but otherwise stops OK. No codes, tone rings and sensors look clean/undamaged. |
View | |
| 2006 Honda CR-V EX 2.4L Back of vehicle Hello everyone, my thanks to everyone that reads this and replies. My apology for not having the V.I.N., its my daughter and son-in-law's vehicle. I only get to see it when there's a problem and my daughter wants me to look at it. Which was about a week ag... |
View | |
| 2008 Kia Sorento LX 3.3L Set Light VIN: KNDJC73508 Car came in to shop with green SET light on on instrument panel whenever car is running. Cruise control works normal. We unplugged all connections at steering column with no change. Removed instrument cluster to check for moisture. None present. There are ... |
View | |
| 2007 Suzuki Forenza 2.0L Poor Idle Quality, Surge, MIL Lamp on, High Idle VIN: KL5JD56Z97 After the car warms up to operating temperature the idle climbs if your above 2000 rpm and you push in the clutch. It is acting like cruise control is stuck and climbing. (It doesn't have cruise) If I reset codes it doesn't do it for about 10 miles. Then k... Trouble codes: P0341 (Camshaft Position Sensor Description) |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2007 Toyota Prius Touring 1.5L overheated output connections VIN: JTDKB20U07 I replaced the relays cleaned and re-insulted the cable ends and the car has been driven numerous miles and many times with no problems or codes. I made sure this time I tightened the nuts plenty tight .. as tight as I think a nut on a 5mm stud can take. So ... |
12 |
