 Prev |
Professional Automotive Repair Technical Discussions for March 23, 2016 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2007 Chrysler 300 C SRT8 6.1L No Start VIN: 2C3LA73W07 Car sat in customers yard for 3+yrs. Towed to shop for a no start issue. Engine turned over but had codes relating to Wireless Control Module or "Halo" on ignition switch. Replaced part and had PCM /key programed. Still wouldn't start. Found the engine had no ... |
View | |
| 2010 Chrysler Sebring Limited 3.5L System Leak VIN: 1C3BC6EV6A Customer states A/C not blowing cold. Checked refrigerant charge. System was almost empty. Checked for signs of leaks and found none. Recharged system and added tracer dye. Returned vehicle to customer. 2 months later, customer returned with same complaint. Ag... |
View | |
| 2008 Dodge Ram 1500 SXT 5.7L etc. VIN: 1D7HU18218 Hello all have a bit of a tricky one here, This dodge truck with start to vibrate/shake through the whole vehicle, at speeds above 70 while on a flat surface cruise (very little load) have tried several things to try and diagnose source but to no avail. Transm... |
View | |
| 2006 Jeep Wrangler X 4.0L Cuts out, MIL Lamp on VIN: 1J4FA39S36 WE got this jeep with the check engine light on.it was missing under load and jerked intermittly at highway speed. Usually sets code on start up,but not always.We took all the auto zone sensors off and put oe crank sensor and cam sensor with oil pump drive.We ... Trouble codes: P0344 (Cam sensor intermittent) |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2002 Dodge Ram 1500 ST 4.7L MIL Lamp on VIN: 3B7HA18NX2 As luck would have it, the failure rate escalated drastically after I wrote the first request so that it was throwing the code consistently after at least every other restart. Measured voltages and grounds looked fine so (as many of you said) it was time for a... Trouble codes: P0601. |
14 |
