 Prev |
Professional Automotive Repair Technical Discussions for September 30, 2015 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 1996 Honda Accord EX 2.2L MIL Lamp on VIN: 1HGCD5653T I have a code p1381 I have replaced both crank sensor and distributor, checked wiring at both connectors for ohms and resistance @1500 ohm at 4 and 5 pins in wiring harness, has anyone run into this before? Trouble codes: P1381 |
View | |
| 2001 Honda Odyssey EX 3.5L No Start, Stall VIN: 2HKRL18651 Takes a few hours to stall. Scan tool hooked up and fuel pressure gauge. Runs great till gets hot then starts running bad like fouled plugs then shuts off. Pulled spark plugs and see weak fire. Good compression. Fuel pressure same. No tach signal on cluster bu... |
View | |
| 2003 Isuzu Axiom XS 3.5L tp sensor VIN: 4S2DF58X53 after I got it back out of the shop I drove the vehial about a month before the tp sensor code was going off replace the tp sensor now it still going to reduce power mode and throws off code [...] is tp sensor to MAF senor correlation then after shutting ... |
View | |
| 2010 Mazda CX-7 Grand Touring 2.3L Extended Crank VIN: JM3ER4W34A Has extended crank when cold, but not every time. When it does act up, coolant temp and air temp sensors match and fuel pressure is at minimum 55 psi up to 600 psi, has high pressure fuel pump. Never bleeds down below 40psi with mechanical gauge or the electro... |
View | |
| 2006 Subaru Outback XT 2.5L Rattle VIN: 4S4BP68C06 Rattle only occurs on rough road surface. It will disappear completely when brakes are applied. Rear calipers seemed to have too much movement when compared to other vehicles so caliper guide pins were replaced. They have very limited movement now, but the noi... |
View | |
| 2004 Toyota Corolla CE 1.8L MIL Lamp on VIN: 1NXBR38E94 Originally came in with check engine-only evap codes-found bad gas cap-performed evap test ok'd-oil and filter and serpentine belt-when customer picked up poo16 was set-cleared-came on-tech checked for stretched chain-said was 12 degrees-we replaced timing cha... Trouble codes: P0016 (Timing correlation) |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2007 Hyundai Sonata GLS 2.4L top engine noise VIN: 5NPET46C87 David was right; fist i cut open the oil filter and found that it was full of metal shavings.Then i disabled each cylinder individualy and it stoped the loudest tick when i disabled #2 i am going to drop the pan but i believe i have enough evidence to say rods... |
8 | |
| 2005 Toyota Corolla CE 1.8L MIL Lamp on VIN: 1NXBR32EX5 Well car is fixed. Drove car with vacuum gauge and lab scope hooked onto purge solenoid by air cleaner housing. After 100 miles of driving found purge valve sticking in open position. Replaced with factory part and cleaned/flushed line to charcoal canister. Th... Trouble codes: P0441 (Incorrect purge flow), P0455 (Gross evap leak detected), P0171 (Lean bank 1). |
11 | |
| 2007 Toyota Camry XLE 2.4L Poor Fuel Economy, MIL Lamp on VIN: 4T1BE46K57 Thanks for all the help. After extensive driving and testing , finally had fuel pressure drop to 35 psi. Spec is 44-49psi. rReplaced fuel pump. All good Trouble codes: P0171 (System lean). |
24 | |
| 2011 Toyota Camry SE 2.5L passenger floor VIN: 4T4BF3EK2B The factory access plugs in the floor were not sealed properly and splashing through water was the cause. resealed and no more water |
10 |
