|Prev||Professional Automotive Repair Technical Discussions for May 3, 2015
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1998 Ford Ranger Splash 2.5L Poor Idle Quality, Hesitation, Misfire VIN: 1FTYR10C3W
Car runs much better after putting the head back on, but still has a rough idle, and a misfire in between shifts. The exhaust pops on decel. Also around 1800 RPM the engine breaks up, not a steady misfire but as if it's losing fuel. Put a scope on ignition c...
|2004 Ford Escape XLT 3.0L Stall
After replacing the two converters car runs and drives great. The problem I am having is when it gets hot it will stall when put in reverse or drive. It will not stall when coming to a stop. I have replaced IAC,smoked intake found one bad vac hose,and taken it...
|2005 Ford Escape Hybrid 2.3L Stall VIN: 1FMCU95H05
Well first off this customer had this Escape towed in to a local Ford dealer because the vehicle would stall and display "STOP SAFELY NOW" message. The vehicle's engine will shut off and the only way to restart the vehicle is to clear the code. The local Ford ... Trouble codes: P1A0C
Fixes & Summaries for Ford
|2009 Ford Ranger XLT 2.3L shift sol b VIN: 1FTYR10D89
Sorry it took so long to close. i needed to make sure this truck was fixed. i followed yalls advise and hooked up a low amp probe to the Sol B circuit at the PCM. while monitoring the fault data and current rate i drove it for a few days. until it finally faul...