|Prev||Professional Automotive Repair Technical Discussions for April 21, 2015
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2008 Chrysler 300 C 5.7L Suspension VIN: D0NTKN0WWH
My personal car. AWD so it does not have tension struts. Turning left at mostly highway speeds you get a very bad/quick rattle from what appears to be the right side and you can feel it in the floor boards. Everything feels tight, I suspect lower control arm b...
|2008 Dodge Ram 2500 SLT 6.7L MIL Lamp on VIN: 3D7KS28AX8
Code P0037. Performed Chrysler's diagnostic circuit test for code P0037 and O2 sensor 1/2 (after DPF) heater resistance is 0.0407 meg ohms which it too much resistance as it should be at 3.2 +/- 0.8 ohms. I already know it needs the sensor replaced, but I also... Trouble codes: P0037 (O2 Sensor 1/2 Heater Circuit Low)
|2010 Dodge Ram 1500 SLT 4.7L Instrument Cluster VIN: 3D7JV1EP0A
Hey everyone, we need help on diagnosis on this truck.we're working on 2010 dodge ram 1500 truck-(esp-bas-traction control lights stay on @ all times.we checked for voltage @ dynamics sensor-found no voltage.located & repaired power wire going to sensor.we sc...
|1989 Jeep Wrangler 2.5L Poor Idle Quality, Stall VIN: 2J4FY19E9K
This Jeep will start up fine and idle high, then it will start idling up and down and up and down all the time. When you drive it and come to a stop, the engine will cut off. It will restart, but we have no scan tool that will hook up to the vehicle so we have...
Fixes & Summaries for Chrysler
|2013 Chrysler 200 Limited 3.6L Steering VIN: 1C3CCBCG6D
William and Nigel, thank you for confirming our thoughts. The rack was faulty. We replaced the rack and all is well. All parts were from Chrysler.
|2003 Dodge Ram 3500 5.9L low power VIN: 3D7LU38C93
Thanks for the responses. I took all the transfer tubes back out, inspected and cleaned and reinstalled. It holds pressure now. I suspect I did not get #6 torqued correctly because it is so hard to get to and it seemed to break loose easier then the rest.
|2013 Dodge ram 1500 5.7L alarm
Now for the rest of the story...turns out the customer put fobix #2 in a hide a key under the vehicle, we get 180" of rain a year here, needless to say the fobix was nothing but corrosion. ordered new fobix. thanks for all the help have a great day!