Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for April 6, 2015
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Asian
Help Request Answers
2006 Honda Pilot EX 3.5L bad throttle respons VIN: 5FNYF28436
CEL comes on when the engine rpms go up to 1700 and the throttle will be very sluggish-will raise rpms slowly. Customer is not able to drive at all. The engine is turned off for a second and on restart everything seems fine. Engine runs smooth and misfire code... Trouble codes: P0300, P0301, P0302, P0303, P0304, P0305
2006 Honda Odyssey Touring 3.5L No Start VIN: 5FNRL38886
van came from the auction all taken apart , I have got everything plugged back in still no start, Honda HDS GNA600 will not recognize that the key is on, so I checked DLC for problems the only problem is with the low side CAN pin14 I had to replace with used t...
2003 Mazda Protege Mazdaspeed 2.0L No Start, Poor Idle Quality, Cuts out, Stall, Misfire, MIL Lamp on VIN: JM1BJ22783
Vehicle sets a P0335 Crankshaft position sensor fault. according to customer vehicle stated having this problem and it became worse and worse slowly. When it 1st starts after it has been sitting for a while it runs fine, After it warms up for a bit, usually ab... Trouble codes: P0335 (Crankshaft position sensor fault)
2006 Mazda 5 Sport 2.3L suspension VIN: JM1CR29366
Knocking noise from right front over bumps and can be felt in car, worse with someone in passenger seat. Replaced front struts with new mounts and stops, no change. Replaced right front motor mount per TSB (verified mount failure) but still no change. Can see ...
1995 Toyota Corolla 1.6L Hesitation VIN: 1NXAE04B2S
Idles good, no misfire. There is no acceleration like convertor is plugged or trans is stuck in 3rd gear. Removed catalytic convertor - no changel Am I missing something?
2004 Toyota Camry XLE 2.4L MIL Lamp on VIN: 4T1BE32K24
Thanks In advance for the help. SO the Car Came In with a P0136 code simple fix right? We replaced sensor 2(this car has 3 sensors, one A/F sensor in the front and two oxygen sensors rear)We replaced the second sensor OSB2 The sensor we got was a Denso sensor ... Trouble codes: P0136

Fixes & Summaries for Asian
Fix/Summary Answers
1996 Acura TL 2.5L Poor Idle Quality, Surge, Stall VIN: JH4UA2651T
sorry for the late close but was away for a bit and had forgot. the vehicle all of a sudden started running normaly and was not acting up. we then noticed that the only thing that changed was the weather, so out came the water bottle and it started running lik...
1993 Toyota Pickup DLX 3.0L Hesitation, Cuts out VIN: JT4VN13D3P
The customer has been unable to return this vehicle to me to complete the work so unfortunately I must close this request with a no fix. Sorry guys. If and when the truck returns I will post anything I find. Again thank you all who pointed me in directions t...
2000 Toyota Tundra SR5 4.7L Misfire VIN: 5TBBT4417Y
Thanks for the help fella's. As it turns out the customer tells me the whole story after the fact. Apparently after closer inspection I could see that the cylinder heads had been recently replaced. I immediately think I've just opened pandora box here. There c...
2003 Toyota Camry SE 2.4L Unknown VIN: 4T1BE32K83
First of all Thank You to all who replied. It is amazing that a new intake manifold cured the noise. Thank you for the input. It is hard to tell a customer they need a $ 300 plus dollar part when it just does not make sense that it would have a noise like that...
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next