 Prev |
Professional Automotive Repair Technical Discussions for February 20, 2015 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2000 Chrysler 300M 3.5L Excessive Emissions, Misfire, Long crank time VIN: 2C3HE66GXY Recieved this car with the 2 codes due to mileage i replaced the 3 sensors atfer reading the responses. The codes came back as soon as the car is started the symtoms are a long crank time,rough idle and excessive tailpipe emmisions [ strong exhaust smell]. Sta... Trouble codes: P0340, P0112 |
View | |
| 2001 Dodge Ram 2500 5.9L No Start, no communication VIN: 3B7KF26661 Good morning, I have here here this dodge that refuses to run. Scan tool won't communicate with either ecm or pcm. When I first started looking at it the wait to start light would blink, then became inop. altogether. According to customer, the wait to start li... |
View | |
| 2013 Dodge Grand Caravan SE 3.6L transmission VIN: 2C4RDGBG0D customer was driving when check engine light came on and trans went into limp mode. codes recorded were 732a, 841, and 882. cleared codes and drove 40 miles, no codes and no symptoms. where do I start ? |
View | |
| 2000 Jeep Grand Cherokee Limited 4.7L alternator VIN: 1J4GW58N6Y Customer complaint, check gauges. Discovered charging system is not working. Tested ckts at alternator-OK. Replace alternator with new MOPAR. Vehicle didn't charge instantly but did start charging after shut off and restarted. Worked fine after that. Released ... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2005 Jeep Liberty Sport 2.8L Excessive Emissions, Black smoke VIN: 1J8GL48575 Ok so I pulled the EGR Valve off and checked it. The valve was sticking I cleaned it and it was not longer sticking then I put penetrating oil in it and let it sit to see if the valve was leaking and it was. I got a new valve (from napa re-boxed factory one) I... |
9 |
