|Prev||Professional Automotive Repair Technical Discussions for February 10, 2015
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1998 Ford Ranger Splash 3.0L Mechanical VIN: 1FTYR10U8W
engine has ticking noise removed valve cover and ran engine replaced lifters noise still present used stethoscope noise appears to be from top end if you unplug number 1 spark plug noise disappears
|2007 Ford F-450 Super Duty XLT 6.0L Mechanical VIN: 1FDXF46P57
bi put a engine in this truck 3 weeks ago from jasper engine.i have no turbo boost & the gage shoes none. the truck had boost befor i replaced the engine. i have on power on hills.i need help if any one has had this problem. thanks charles
|2011 Ford Fiesta SE 1.6L Abs Module VIN: 3FADP4BJ7B
Hello techs,just reaching out to see if anyone expeirienced the abs module lossing communication.vehicle came in to program rcm.programmed rcm and cleared cmdc's.code u3002-62-0a was left.so looking up procedure told me to reprogram abs module.upon doing so pr...
Fixes & Summaries for Ford
|1998 Ford F-150 Lariat 5.4L Cuts out VIN: 2FTRX18LXW
Well, after much searching and banging my head against the wall I think I got it. I checked for pinched wires, bad grounds, 5V reference, everything I could think of and was about to move on to scoping each input signal to the PCM ( or give up) when I found an...
|2002 Ford Explorer XLT 4.0L 4 wheel drive VIN: 1FMDU73E62
Sorry for the late close,it was put on the back burner as this is a third vehicle for them, so it wasn't a rush. After starting on vehicle again and repeating previous test with out gaining ground, I disconnected plug at transfercase and the code 1824 disappea...
|2003 Ford Expedition XLT 5.4L vent temperature VIN: 1FMPU16LX3
Ok guys, got it fixed. I pinched off the hoses for the heater core and the air temp did get cooler, so I knew the door was either broken or stuck. Since that bugger is buried way in there, I decided to check the signal at the plug first. Sure enough, it was...
|2004 Ford Escape XLT 3.0L Misfire VIN: 1FMCU03174
Sorry for the delay in closing this request. After running all the tests we had already ran and looking at most of the recommendations, we went back to the basics. The tech that started looking at this vehicle is no longer employed here. We pulled all of the s... Trouble codes: P0301 (Cylinder 1 misfire).
|2006 Ford Five Hundred SE 3.0L Hesitation, MIL Lamp on VIN: 1FAFP23196
Hi There, Did some datastream monitoring and it all led up to replacing the cvt transmission. Thanks for all the input on this problem. Mike Trouble codes: P0701 (Tcs range), P0720 (Output speed sensor), P0730 (Gear ratio), P0811 (Clutch slippage), P0868 (Fluid pressure), P0871 (Pressure switch).
|2007 Ford Ranger XLT 3.0L Poor Idle Quality, Misfire VIN: 1FTYR44U57
first thank you for everyone's input.. Timothy and Robert gets the ribbon this time :-) when you unplug a o2 it does try to fatten it up a little. so what I had was a very small leaky #6 injector when truck was running and o2 plugged in the o2 was trying to c... Trouble codes: P0304, P0305.