|Prev||Professional Automotive Repair Technical Discussions for December 15, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2005 Chrysler 300 Limited 3.5L Unknown VIN: 2C3JA53G65
After R&I transmission for flex plate replacement, flex plate had stripped teeth, transmission is stuck in 2nd gear which i believe to be limp home mode. i have double checked all connections and made sure there are no pinched wires. all grounds are hooked up ...
|2007 Dodge Dakota SLT 3.7L Stall VIN: 1D7HW48KX7
Hello Everyone. Thanks in advance for your assistance. I have a 2007 Dodge Dakota that's giving us fits. This vehicle will run great with absolutely no problems and then it will stall with no apparent pattern. It will immediately restart. It will also stall af... Trouble codes: P0884 (Power up at Speed w/automatic transmission), P0522
|2010 Dodge Journey SE 2.4L Low Reverse Solenoid Circuit VIN: 3D4PG4FB6A
The vehicle came into the shop originally with a P0750- Low Reverse Solenoid Circuit and P0731- Gear Ratio Error in 1st. The transmission filter was full of clutch material so we had pulled the transmission out and rebuilt it. Only to find the torque convertor...
Fixes & Summaries for Chrysler
|2001 Dodge Ram 3500 5.9L gauges, no communication VIN: 3B6MF36651
I have not been able to duplicate the problem long enough to find the problem. I believe the problem is in the wire harness to the cluster or the cluster itself. When you move the harness the problem went away and has not returned. Thank you to all who offered...
|2004 Dodge Stratus SXT 2.4L No Start VIN: 1B3EL46X14
Thanks for all the good input. found exhaust cam pin sheared off allowing cam sprocket to slip on camshaft. Lets hope no internal engine damage was done.
|2004 Dodge Ram 2500 ST 5.9L cruse control VIN: 3D7KU28C04
found that this system uses the injectors for slow speed cruse control and then later engages the cable. found that the cable was broken and was causing all the problems is now good to go. have to watch the test for servo because will test bad if cable broken.