Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for December 3, 2014
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2005 Chrysler 300 Limited 3.5L Misfire, MIL Lamp on VIN: 2C3JA53G85
I need some help from you Chrysler techs out there. I have this Chrysler 300 that miss only at 55mph and up Scan tool confirms this under a load only. Dragging the brakes to dis engage lock up converter makes no difference. Tried a new coil with no results. mo... Trouble codes: 300 (miss fire), 304 (miss fire cyl 4)
1993 Dodge Dakota 5.2L No Start VIN: 1B7GL23Y7P
Customer had installed 4 aftermarket rem pcm's all failed within a week. I was not informed about this so diag showed a bad pcm. I replaced pcm with a dodge rem and within a week it was back in with a no start. Replaced pcm again with a dodge rem. I have cked ...
1998 Dodge Ram 3500 5.9L Fuel Gauge VIN: 1B7MC33DXW
Fuel gauge reads empty all the time. Customer said tank is full right now and there is a fifth wheel hitch bolted through frame so I would like to try and narrow down the cause before I start taking things apart. I found the connection behind the left front ti...
2000 Dodge Grand Caravan 3.0L rack and pinion VIN: 2B4GP2434Y
steering wheel shimmies at low speeds like bent axle. installed both axles slight change but still there. center check on eng seems fine rotating tires no change. all other front end parts are tight. struts need replaced but don't see how they would make this ...
2010 Dodge Caliber SXT 2.0L interior heating VIN: 1B3CB4HA2A
when car is in the shop, we can raise the rpm's to 1600 and the car will maintain good heat after reaching op temp. fans kick on as they should, when test driven the temp drops rapidly, can watch on scanner, also heat becomes cool.

Fixes & Summaries for Chrysler
Fix/Summary Answers
1998 Dodge Ram 2500 5.9L Poor Idle Quality, MIL Lamp on VIN: 1B7KC2365W
Thank you all for all the great replies,we inspected all suggestions.Turned out to be a bad ECM on the block.Replaced,good as new.I appreciate you all taking the time to help lead me in the right direction.Thanks again Trouble codes: P0215.
2008 Dodge Charger SE 2.7L Mechanical VIN: 2B3KA43R08
Thanks for the responses. We checked the wiring harness to trans mission, all looked ok. I went on the Chrysler website and installed latest flash for the pcm. Road tested and so far the po869 line pressure high code hasn't returned. Before it would only take ...
2012 Jeep Grand Cherokee Laredo 3.6L Steering module VIN: 1C4RJEAG7C
Thanks to all you guys. I think I can safely say the clockspring which contains the steering control module needs to be replaced in the event of air bag deployment. The lot owner replaced with a new one now I have codes for the Lin data line circuit between T...
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next