|Prev||Professional Automotive Repair Technical Discussions for December 2, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2007 Chrysler Pacifica Touring 4.0L Fuel Cap Light VIN: 2A8GM68X17
This car keeps resetting the fuel cap light. I'm assuming it has a gross EVAP leak somewhere but we can't locate it. We tried the fuel cap just to make sure that was ok. Smoke tested the system and couldn't find anything. Is there something common on these car...
|1999 Dodge Ram 2500 5.9L Quick shift from 2nd to 3rd VIN: 3B7KF2369X
Hi All, Thanks in advance. This truck came in for a shifting problem from 2nd to 3rd. It starts out in 1st and then goes to 2nd gear and quickly shifts to 2nd to third. It doesn't stay in 2nd gear as long as it should. Fluid was burnt. Thank you, Mark
|2005 Dodge Ram 1500 ST 5.7L cylinder 1 misfire VIN: 1D7HA18D75
Hey guys, new member here. I have this 05 Ram that is driving us nuts! Keeps coming up with cylinder 1 misfire (p0301). I've gone through all the tests, and come up with nothing. Watching misfire counter, cylinder 1 starts misfiring under load fairly consisten...
|2008 Dodge Charger SE 2.7L Mechanical VIN: 2B3KA43R08
Evening all. Need a little help with this Dodge. It came in with a no shift and codes p1745 and p0869. After checking the basics and clearing the codes, P1745 wouldn't clear and the trans stayed in limp mode. I cleared the transmission learned values and clear...
|2005 Jeep Liberty Limited 2.8L fuel injector VIN: 1J8GL58525
number 4 fuel injector wont hold compression for more than 10 minuets with a new copper gasket and o ring. keeps blowing out injector seal.
Fixes & Summaries for Chrysler
|2007 Dodge Caliber SXT 2.0L Transmission VIN: 1B3HB48B87
Thanks to all that replied. Although it appears that you can transfer the module and get away without reprogramming our vehicle had not had any of the TCM or PCM updates done to it. We were lucky to have a factory trained tech available with all the updated so...