 Prev |
Professional Automotive Repair Technical Discussions for November 13, 2014 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2008 Acura MDX 3.7L brakes hydraulic VIN: 2HNYD28258 Vehicle came in for brake fluid flush. Had normal brake operation prior to this. I opened the R/F & R/R brake bleeders. Installed clear vinyl lines to the bleeders [open 1/2 turn] & submerged the open ends of the lines into containers of clean brake fluid. I t... |
View | |
| 2004 Toyota Sienna XLE 3.3L vsc VIN: 5TDZA22C24 I have this sienna that is activating the vsc system when customer is going on a turn and there are no codes. at first i thought a bad yaw sensor then i read this tsb # br008-04 that says angle sensor but from stop to go activation not very specific about turn... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2007 Nissan Sentra SE-R 2.5L I/M Readiness VIN: 3N1BB61E27 Thanks for all the replies. This one was not as difficult as I thought it would be. Clearing codes in the ECM, even though there were none, reset all the monitors, but did not change the MIL Command Status. So, like one member suggested, dead heading the cable... |
7 | |
| 2005 Subaru Legacy GT Limited 2.5L engine starting system VIN: 4S3BP67655 first of all i would like to say thanks to the 3 techs that responded to my request.with your help i was able to find the problem.traced the main relay circuit and found blown fuse that provides power to main relay sbf-7 30 amp fuse/link.replaced it and vehicl... |
3 |
