 Prev |
Professional Automotive Repair Technical Discussions for October 4, 2014 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2001 Honda Accord LX 2.3L Poor Idle Quality, Hesitation, Misfire, MIL Lamp on VIN: JHMCG665X1 ok this is the problem guy, please help . car came in for timing belt and waterpump. it run fine but after the job it run rough at idle # 4 misfire check engine light flash. I pull plug wire out at idle no change but high rpm pull out it shake indicate it work... Trouble codes: 300 (random misfire chech engine light flash) |
View | |
| 2009 Nissan Maxima S 3.5L intellikey - starting VIN: 1N4AA51E89 This was towed in - no start, key not recognized. Using a snap-on solus ultra we could go through about 80% of the diagnostics leading to the steering wheel lock module. Replaced with reservations, as the last part of the procedure is to register the intellike... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 1993 Honda Accord LX 2.2L No Spark VIN: 1HGCB7658P Thank you IATN group, specially the 15 of you that took time to respond. The fix was a ground wire at thermostat housing, the bolt was loosed and the ground wire come off, caused all that problem.` I reverse all that swapped parts, the car runs fine. |
15 | |
| 1991 Mazda RX-7 Turbo 1.3L No Start VIN: JM1FC3526M after finding out that only two of the injectors fire until a certain rpm. I tested the other two injectors (under the intake) and found I had noid. I also found one of the three grounds at the computer wasn't any good. I fixed the ground at pcm. Removed spark... |
5 | |
| 1997 Toyota Corolla DX 1.8L Poor Idle Quality, Hesitation, Stall Hi everyone and thanks again for all the help, I really appreciate it! It was in fact a dirty IAC, the rotary vain had sticky carbon on half of it only allowing the vain to open about half way, I really didn't think it was the IAC because like I said it ran f... |
20 |
