Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for September 15, 2014
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
2003 Ford F-350 Super Duty XLT 6.0L a/c blower VIN: 1FTSW31P63
Good morning Ladies/ Gentlemen, I need you HELP on this internmitting problem Customer came in complaining that his a/c blower was not working/ i check the blower motor fuse F2-28 it was blown. Replace the fuse the blower work. Customer called a week later tha...
View
2003 Ford Excursion XLT 5.4L pressure readings VIN: 1FMNU40L63
Hello, truck came in with the low side at 75 psi and high side needle fluctuating really fast from 200 to 275 psi. The a/c blowing about 78 degrees from the front vent and about 66 from rear vents. I took out the orifice tube and it had some particles and al...
View
2003 Ford F-250 Super Duty Lariat 5.4L door ajar radio int light VIN: 3FTNX21L23
origenal problem was open drivers door radio and lights on interior would not work properly after vsm replacement doors open show closed when closed show open on scanner
View
2003 Ford Expedition Eddie Bauer 5.4L engine VIN: 1FMEU17LX3
Vehicle came in no start from another shop.
View
2005 Ford F-250 Super Duty King Ranch 6.0L MIL Lamp on VIN: 1FTSW21P85
vehicle came in on 1st visit with sel on. setting P0606. sent ecm off for repair,repair center said not repairable. replaced ecm and programed. customer returned said fuel gauge wasn't accurate. didn't know if it was a programing issue, found wrong vin in comp... Trouble codes: P0606, P1102, P1635
View
2005 Ford Freestyle SEL 3.0L Unknown VIN: 1FMZK02185
Hi, every one this suv came in with inoperative compressor. So we changed the compressor, dryer, expansion valve and flash the system. Now with compressor running and temp. Set on 60 degree my low pressure is about 65 psi and high pressure about 190 psi and at...
View
2007 Ford Escape Hybrid 2.3L power steering VIN: 1FMCU59H67
Hello, Been trying to get as much info for diagnosing this hybrid steering system Michel is not too in depth on the subject. The module is telling me to the motor is bad, replaced gear and same problem. Now before I go throwing another 500 at this thing i want...
View
2010 Ford Explorer Sport Trac XLT 4.0L MIL Lamp on VIN: 1FMEU3BE9A
Truck came in with multiple codes and complaint of stalling once when waiting for a lite.After checking FF data I cleared codes.Owner needed for work.Checked for tsb's and there were none. All six parts share the same power source.Came back today all six codes... Trouble codes: P0053, P0054, P0059, P0060, P0403, P0443
View

Fixes & Summaries for Ford
Fix/Summary Answers
1967 Ford Galaxie 500 4.7L Mechanical VIN: 7J56H10650
Wow. Thanks everybody for the great inputs, The casting number on the driver's side block proves it 100%to be a 390 engine. (6.4L) The most response I ever got...
43
1996 Ford E-150 Econoline 5.8L Power Steering VIN: 1FDEE14H2T
Most replies suggested air, but I was sure that wasn't the cause unless it was trapped somehow. I took the pump off with the two lines, flushed them out, and blew through them to check for "flappers" as suggested, and something I considered as well. I rep...
20
2006 Ford E-350 Super Duty XLT 5.4L abs, trac VIN: 1FBSS31L86
Thanks to all that replied, looked deeper into this problem and noticed that the second time we scanned vehicle, it had a code for ECU malfuntion. removed connector from ECU and found corossion on plug, cleaned it and everything is back to normal, ABS and trac...
11
2006 Ford F-250 Super Duty XLT 6.0L No Start VIN: 1FTSW21P76
sorry for the delay on the fix. it was the injectors. they were leaking internaly. Trouble codes: P2290 (Icp too low).
25
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next