 Prev |
Professional Automotive Repair Technical Discussions for August 14, 2014 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2006 Dodge Ram 2500 SLT 5.9L compressor VIN: 1D7KS28C56 Vehicle came in with no a/c. Hooked up gauges and press are good. No compressor clutch activation. since it is controlled by the tipm, their is no relay to check.. when u cycle the a/c switch inside the cab the engine changes sound and acts like the clutch is ... |
View | |
| 2011 Dodge Durango Crew 3.6L MIL Lamp on VIN: 1D4RE4GG4B Came in with 2 history codes, p0300 & P0152(o2 high b2s1) and pending code of p2098(downstream fuel trim 2 lean). Pending p2098 went to "active" after a few min of idling. Cleared codes with initially only p2098 coming back. While monitoring FT's, LT & ST both... Trouble codes: P2098, P0152 (O2 High B2S1history), P0300 |
View | |
| 2004 Jeep Grand Cherokee Overland 4.7L Poor Idle Quality VIN: 1J8GW68J54 HI Everyone Got A jeep Here 4.7 Came in with Coolant getting in the Number 1 Replaced Head Gaskets Milled Head .005 replaced valves Replaced timing Tensioners and guides now it runs rough at idle long term fuel trim on left bank is a -32 and left bank right b... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2007 Chrysler Pacifica Touring 4.0L MIL Lamp on VIN: 2A8GF68X37 It ended up being the sending unit. I rechecked the vehicle with my Autel Maxidas and that showed me a P0463 (Fuel level signal high)in the central gateway ECU. For some reason this code never showed up on my Solus. Reading the values on the scanner showed 10... Trouble codes: U1403. |
4 | |
| 2000 Jeep Grand Cherokee Laredo 4.0L No Start VIN: 1J4G248S7Y Hey guys, thanks for all the helpful replies!! Tim, the check engine light was off when the key was first turned on, but it would come on after about 40 seconds. None of the gauges worked either... I could supply a ground to the ASD relay and make the relay ... |
11 |
