|Prev||Professional Automotive Repair Technical Discussions for July 22, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2004 Chrysler 300M 3.5L No Start VIN: 2C3HE66G94
This vehicle has intermittent no start, code PO340,344 cranks sensor, has had three sensors one from other shop, one at dealer ship one from us, odd thing we found is when fails and we back prob to scope sensor engine will start, first thought maybe pin damage... Trouble codes: P0340, P0344
|2005 Chrysler PT Cruiser Touring 2.4L MIL Lamp on VIN: 3C4FY58B75
checked voltage at sensors is ay 12 volts but duty cycle dose not change. Trouble codes: P0031, P0037
|2005 Dodge Durango SLT 5.7L Stall, MIL Lamp on VIN: 1D4HB48D75
at times no start, then will start. Sets crank position code. customer replaced crank sensor, I replaced cam sensor. seemed fine. They came to pick up after hours and wouldn't start, then starts, dies, etc. Only code is crank sensor code. running inside the sh... Trouble codes: P0339 (crank position code)
Fixes & Summaries for Chrysler
|1988 Dodge D150 5.2L Poor Idle Quality, Surge VIN: 1B7HD14YXJ
OK Gentlemen, This one is fixed. I first want to thank EVERYONE for their helpful information and things to verify that the origional Chrysler information doesnt really explain. It sucks that the repair information requires a compatible scan tool to do any tes...
|2000 Dodge Grand Caravan SE 3.3L Monitors VIN: 1B4GP44GXY
Replaced the front O2 sensor again with a Denso unit, The customer had originally replaced it withe a Bosch from A/zone. Disconnected battery and shorted cable together again. Restart showed 25% ethanol again and in first 4 minutes of driving went up to 31%. H...
|2004 Jeep Grand Cherokee Laredo 4.0L steering control VIN: 1J4GW48S44
7-22-'14: Looking over the front end of the Jeep we noticed the RH lower forward control arm bushing had rust around its opening. Bushing 'felt' OK in place & bolt was tight. I unbolted the piece and checked on the bench. Bushing was not torn nor wobbled out. ...