Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for July 17, 2014
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2001 Dodge Ram 2500 5.9L Hesitation, Poor Fuel Economy, lack of power VIN: 3B7KC23711
Hello fellow techs, We have this Cummins powered Dodge that was brought to us in Feb. with complaints of extended start time and a drop in fuel mileage. It had a code PO230 relating to transfer pump failure, testing revealed it had a failed pump and we put in ...
View
2002 Dodge Ram 2500 5.9L Hesitation VIN: 3B7KF23662
Need some help on this one. I have intermittent power loss with this diesel. It is not consistent. I did have a fuel injection timing code ( will post with an update I'm not at the shop and can't remember the code) I checked the fuel volume from the supply pum...
View
2007 Dodge Sprinter 2500 3.0L Hesitation, Surge, Misfire, MIL Lamp on, bucking, white smoke VIN: WD0PE845X7
hi this sprinter it has like an on off switch as soon as i give it full load it starts bucking it has no power if i hold it long enough it will start smoking out white smoke. after it gets hot it has even less power it cant go past 2500rpm it constantly bucks.... Trouble codes: 2359 (charge pressure control boost pressure too low)
View
1998 Jeep Cherokee Classic 4.0L Misfire VIN: 1J4FJ68S8W
Good morning Got a very strange one here, misfies on #1 cyl only when trans is in reverse. Runs excellent in all forward gears. with no misfires at all. Thank you for any suggestions
View
2000 Jeep Grand Cherokee Laredo 4.0L Poor Idle Quality VIN: 1J4GW48S4Y
After replacing coil,and pigtail,and ecm,cam sensor i still get code po352 if i reset cam and crank it takes a about 10 start ups to start acting up again,checked compression in cylinder #2 i have 130 cranking compression,new plugs had been installed, and stil... Trouble codes: P0352
View
2004 Jeep Grand Cherokee Laredo 4.7L engine VIN: 1J4GW48N34
Need some direction fellow techs. Thank you for your time first and foremost. This Jeep came in for starter replacement, per customer request, riding on back of a flatbed. No inspection/testing wanted. Neighbor said it needed one I guess. No questions were...
View
1992 Plymouth Voyager 3.0L No Start VIN: 2P4GH2534N
hey we did a water pump timing belt seals , and intake gasket and now I cant get it to start I have 45 psi fuel pressure, I have injector pulse and yes I took the cover back off to recheck my timing marks and they are on the marks for sure but cant get it to r...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
2003 Dodge Ram 1500 Laramie 5.7L Poor Idle Quality, Misfire VIN: 1D7HU18D43
I have done a Fuel Pressure test, 50 psi. Throttle Body Cleaning, removed from vehicle and cleaned. Fuel Injector cleaning. Disabled fuel pump, disconnected line at fuel rail and connected fuel injector cleaner. unplugged #1 coil and pulled ignition coil that...
15
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next