Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for April 7, 2014
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2007 Dodge Ram 1500 ST 4.7L Misfire VIN: 1D7HU18P87
Hello and thanks in advance for taking time to read this. I have a 2007 dodge ram 1500 4.7 that initially came in for the CEL on. upon inspection found P0301 and tests showed to have low compression on the cylinder, leakage test showed to be leaking past intak... Trouble codes: P0300
2011 Dodge Grand Caravan Express 3.6L heater VIN: 2D4RN4DG5B
Good day guys and gals 011 dodge caravan that blows hot at all times on pass side only normal operation on drivers side as well as the rear heater ac unit. scan tool reads no codes present. can read data from hvac but it shows data from left side only--- launc...
1995 Jeep Grand Cherokee Laredo 4.0L abs VIN: 1J4GZ58S0S
having trouble getting brake pedal on this jeep. bleed systom manualy then tryed to bleed with scanner but get no communication, i have power on pin 33 of the module, i ohmed all the inlet and outlet valves on the pump motor, all ohmed ok, (there is a posted f...
1997 Jeep Wrangler SE 2.5L No Start VIN: 1J4FY29P0V
hello we have a 97 wrangler towed in no start. it was running they shut it off sat for a day then wouldn't start. I have no spark and no fuel. connected the scanner but couldn't communicate. I then checked for 5 volt ref and had none. so I went and disconnecte...

Fixes & Summaries for Chrysler
Fix/Summary Answers
2004 Dodge Ram 1500 ST 4.7L Poor Idle Quality VIN: 1D7HU18N44
Hi guys! I want to thank everyone for their help. Most replies felt it was a vac leak as it turned out it was. Truck stopped would idle at 750 rpms. Desired idle is 600,so it actually was idling faster than it should. Just not fast enough to set an alarm o... Trouble codes: P0507.
2008 Dodge Nitro R/T 4.0L Stall VIN: 1D8GUE8698
Ok techs, thanks for all the help. weve gone thru this vehicle applying all the directions received and found no problems. Stalling is very intermittent, one week it goes without, the next it stalls 3 times in 10 minutes. I suspect a damaged TIPM unit. We se...
1997 Jeep Grand Cherokee Laredo 4.0L ignition VIN: 1J4FX58S7V
hey guys, the PCM was bad, did the tap test before but showed no problems. pulled the pcm away from the firewall and flexed in my hands...bam! dies every time. thanks for the input guys!!!
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next