|Prev||Professional Automotive Repair Technical Discussions for November 23, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for European
|2006 BMW 750Li 4.8L Timing VIN: WBAHN83526
Vehicle came in was smoking rebuild engine no more smoking, But I getting code 2A8E and 2A8F tooth off set intake cam to crank gear , checked timing 3 times with tool perfect replace intake sensors same problem pulled out the Vanos cleaned and installed same p...
|1979 Saab 900 EMS 2.0L water pump
Can't find anything on line as far as pictures of engine,mainly water pump replavment.Seems to be a distributer type pump,shaft/gear assymbly going though block.did find a part listed on car quest for 300 but need an saab tech or old timer to help me determine...
|2001 Volkswagen Beetle GLS 1.9L injection pump VIN: 3VWCP21C41
I have this beetle that was towed in to my shop with a bad alternator, I noticed a fuel leak coming from the top cover of the injection pump dripping down on the alternator. I called the dealer and they tell me a gasket is not available for the cover and that ...
Fixes & Summaries for European
|2004 BMW 325xi 2.5L oil pressure VIN: WBAEU33434
Very interesting resolution to this problem: what stopped the oil pressure light flickering at idle on this BMW was a modification to the connector to the oil pressure switch. The connector from the harness side has two female openings, only one of which has ...
|2003 Mercedes-Benz C230 Kompressor 1.8L battery VIN: WDBRF40J23
Well after disconnecting everything in the car and then disconnecting the fuse block by the battery in the engine compartment I still had a massive draw. I disconnected the alternator and starter no change, I then did a continuity test between the POS cable an...
|2004 Porsche Cayenne 3.2L Transfer case VIN: WP1AB29P64
Ist servo motor from WP was defective,and needed updated module as per Porsche tsb for code 2039.This was not immediately throwing this code so that explains my confusion.So in a nut shell replace module and servo motor when you encounter this problem.