|Prev||Professional Automotive Repair Technical Discussions for November 3, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for GM
|1992 Chevrolet S10 4.3L engine stall VIN: 1GCCT14Z5N
Engine will start run for couple of seconds then die
|1993 Pontiac Grand Am GT 2.3L MIL Lamp on VIN: 1G2NW14A3P
Ok so this 93 grand am comes in from another shop were the engine was replaced and they couldn't get it running.brought the car in and looked like it had been sitting for along time.check fuel pressure-no pressure check power and ground ok.replace fuel pump no...
Fixes & Summaries for GM
|1988 Chevrolet K1500 Cheyenne 5.7L Poor Idle Quality VIN: 2GCEK19K5J
Well, I tryed all your great tips, plus I had a donor truck to swap parts from,but after going through all the great tips and ideas, i did't fix the truck. The IAC counts show the 130-140 range but the IAC stays retracked.Tryed ECM recheked grounds and wiring ...
|1998 Chevrolet K1500 Cheyenne 5.7L oil pan VIN: 2GCEK19RXW
thanks for all the input. first of all, I may not have been clear in my post. I changed the oil pan gasket due to a small leak in the rear, then had a larger leak in the front. Alot of the replies were for oil pan or front cover issues, so i decided to replace...
|2000 Chevrolet Blazer LS 4.3L Shift Module VIN: 1GNDT13WXY
It turned out to be the vacuum solenoid on the back of the motor in front of the distributor!Replaced the solenoid.turned the key on the #15 fuse did not blow out like before.Test drove checked 4WD operation the 4Wd switch engaged in all gears!