
![]() |
Professional Automotive Repair Technical Discussions for September 27, 2013 International Automotive Technicians' Network (iATN) - Members Only |
Next ![]() |
(Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. |
Open Help Requests for Asian
Help Request | Answers | |
2006 Acura TSX 2.4L V-tec VIN: JH4CL96806 The eng lite resets every road test, p0011-cmp [v-tec] performance.. looked at the trouble tree, Checked oil LEVEL, and PRESSURE at hot idle and at 3000rpm, no problem.. removed solenoid at rear of block-above filter, tested solenoid for movement and checked p... |
View | |
2007 Kia Sedona 3.8L Hesitation, Surge, Misfire VIN: KNDMB13307 this vehicle came in with a blown head gasket, replaced head gasket also had to re-tap block due to head bolts pulled threads out when removing heads but there was no check engine light nor drivability issue with the vehicle before the head gasket was replaced... Trouble codes: 171 (bank one lean), 174 (bank two lean), 301 (cylinder one misfire), 303 (cylinder 3 misfire), 305 (cylinder 5 misfire) |
View | |
2004 Mazda RX-8 1.3L Poor Idle Quality, Misfire VIN: JM1FE17N54 Check engine light on with the three code. The vehicle had a rough idle and burning white/gray smoke for the first couple minute. The vehicle will start but check engine light will flashes in a few minute and might died on the road. Check spark plug, ignition ... Trouble codes: P0302 (Cylinder misfire detected), P0506 (Idle control system rpm low), P0125 (Insufficient coolant temperature for closed loop) |
View | |
2008 Nissan Xterra X 4.0L MIL Lamp on VIN: 5N1AN08W98 Vehicle returned after repairs with Service engine light on. Diagnostic code P0021 for intake timing control. Dis-assembled to confirm cam timing was correct.Upon inspection, cam timing was confirmed correct. Reassembled and road tested. Service engine light c... Trouble codes: P0011 (Intake valve timing bank 1), P0021 (Intake valve timing bank 2) |
View | |
2005 Scion xA 1.5L Clutch VIN: JTKKT62425 Customer complained started out cold in AM and when got to a stop clutch stayed engaged with pedal at floor. She had problem with getting into gears after that. Drove it in and left it with us. When I first got into it the pedal had a lot of freeplay and trans... |
View | |
1997 Toyota Camry CE 2.2L No Start, Cuts out, Stall VIN: JT2BG22K5V hi all, this car came in 3 months ago with intermittent stall.plugs were burnt out,wires were original,so i replace them and off she went.3 weeks later said it was happening again.it never happened to me.i replace both ignition coils and off she went.2 months ... Trouble codes: P1300 (No igf signal to ecm) |
View |
Fixes & Summaries for Asian
Fix/Summary | Answers | |
1995 Toyota Corolla DX 1.8L ignition VIN: JT2AE09B4S thanks for all your help,this car had been sitting for a long time, found a pwr wire to ecm had been chewed thru, by a critter. under the dash, again thanks for all the replies. |
11 | |
1998 Toyota Sienna LE 3.0L Misfire VIN: 4T3ZF13C6W well i finally got this one done!what ended up happening was the #2 injector crapped out between the time i picked the wires at the #6 coil,reattached and started the motor.had to be less than 30 seconds.apart.now it works,now it dont.thing is i marked the ori... Trouble codes: P0302. |
6 | |
2010 Toyota Camry SE 2.5L Abs /Track VIN: 4T4BF3EK6A found the lf speed sensor loos tighten sensor clean axle clear code test drive no codes. |
3 |