|Prev||Professional Automotive Repair Technical Discussions for September 6, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2005 Dodge Ram 1500 Truck ST 5.7L bank 1 1,3, 5, 7 VIN: 1D7HU18D35
Misfires on cylinders 1, 3, 5, 7 only while in park and neutral ragardless of temperature. Misfires go away while in gear.
|1994 Jeep Grand Cherokee Limited 5.2L air bag VIN: 1J4GZ78Y4R
I need someone to tell me where data link connector for air bag system is located in this jeep . According to alldata it shows to be somewhere on right side of center console . Air bag light is illuminated on dash and i need to find out why . Any help will be ...
|1998 Jeep Grand Cherokee Limited 4.0L instrument panel
This is a 4x4 used on an island. The gauges quit one day going from the harbour to his cottage. The fuses are good that show on the wiring diagram. I have to travel by boat to check this again so it would be great if there was someone that has seen this before
Fixes & Summaries for Chrysler
|2001 Chrysler Sebring LXi 2.7L Cooling Systems VIN: 1C3EL55U51
Sometimes one overlooks the obvious. The reservoir cap was bad, causing the coolant to overflow, not allowing the system to pressurize, therefore, air stayed in the system, which stopped the fans from coming on. Thank you all for your suggestions.
|2003 Chrysler 300M 3.5L in limp mode VIN: 2C3AE66G73
Timothy from Wisconsin gave me a great idea.Reset code after vehicle is running.I did and vehicle came out of limp mode.Took vehicle for a long test drive it shifted fine,but it gave a code p0846(2-4 pressure sw. sense circuit).Found open circuit fixed it and ...
|2006 Dodge Charger R/T 5.7L Unknown VIN: 2B3KA43H06
Well I did fix this car. Like I said it didnt have any thing to do with the freon it was a electrical problem.Late yesterday I got the car back and tried to calibrate the ACTUATOR CALIBRATION and it passed the test so I tried to manualy test the cooldown test ...