|Prev||Professional Automotive Repair Technical Discussions for January 5, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|2000 Ford Expedition XLT 4.6L ring/pinion VIN: 1FMRU1662Y
Vehicle came in with a leak from the diff cover. one of my techs discovered severely worn inner axle shaft bearings and upon further investigation found the pinion bearings to be worn. The customer agreed tto having these items replaced. My tech goes to work o...
|2000 Ford F-350 Super Duty XLT 6.8L Hesitation, Cuts out
Hello all ford techs out there. federal emissions chasis cab. This truck came in 2 weeks ago and wouldn't idle or at least not very well, had absolutely no power what so ever. I plugged in with my soulus ultra and looked what was going on. The maf was way off ...
|2005 Ford F-350 Super Duty King Ranch 6.0L injector pressure reg no switch ground VIN: 1FDWF36P05
hi guys i have a tow truck it started as a engine swap then the customer requested to do arp studs we have done those before with no problems before customer supplied engine and said it ran fine in another truck we did the heads now it starts and dies in 3 sec...
|2009 Ford F-150 XLT 4.6L Cuts out, Stall VIN: 1FTRF12W09
Hello Ford wizards, this truck is driving me nuts. About four weeks ago this nightmare pulled into my lot. It had its CEL on and the owner said he was afraid to let his wife drive it because it would out of the blue just plain out stall and if you were in the ... Trouble codes: P0150 (Sensor circut bank 2 sen. 1), P025A, P0297 (Vehicle over speed condition), P0690 (ECM / PCM Power relay sensor circut high), P1000 (OBD systems readiness test not complete), U0109 (Lost communication with fuel pump control module)
Fixes & Summaries for Ford
|1992 Ford F-350 Custom 7.5L Mechanical VIN: 2FTJW36G6N
Sorry for the delayed fix-I had to wait almost two weeks to get the approval to move forward on this truck-The final fix was updating the master cylinder to a f-450 style-Installed it with very little trouble and gave the truck a good gravity bleed-No more spo...