 Prev |
Professional Automotive Repair Technical Discussions for December 31, 2012 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for GM
| Help Request | Answers | |
| 2005 Buick LaCrosse CXL 3.8L Turn signal/Hazard Flasher VIN: 2G4WD56245 Customer complaint of no "clicking" sound when turn signal/ hazards activated, but lights operate correctly. Ordered a GM Flasher Module([...]) but cannot locate flasher in vehicle.Repair software says it is located below left side of dash near BCM .Labor g... |
View | |
| 2006 Chevrolet Impala LS 3.5L power steering pump,gear VIN: 2G1WB55K06 Vehicle came in with hard steering at idle but pump not making noise. Replace pump with OEM part, bled as instructed in alldata. New pump making noise and easy to turn on start up. After vehicle warms up pump make no noise but steering is hard to turn, can hea... |
View | |
| 2002 GMC Sierra 1500 SL 5.3L battery VIN: 2GTEK19T52 I have a major draw on the battery. If vehicle sits for a couple of days without being started the battery goes dead. Memory had 2 codes B1477 & B2647.I've removed every fuse,circuit breaker,Module connectors,door switches,seat harness,bulkhead connectors,igni... |
View |
Fixes & Summaries for GM
| Fix/Summary | Answers | |
| 2000 GMC Jimmy SLS 4.3L No Start, Cuts out VIN: 1GKCT18W7Y Thanks for the support techs. A fuel pump fixed this beast. The pressure with the new pump was only a couple of pounds higher but now in starts cold. With the old pump I cracked the bypass on my gauge with the engine idleing and the pressure went instantly to... |
23 | |
| 2003 Saturn Vue 3.0L steering/ suspension VIN: 5GZCZ53B03 Thanks for all the feedback. This vehicle is two wheel drive and it does not have a cvt trans. It turned out to be a bad axle/axles. The way I figured it out is I put it on the rack and had someone operate it at 70mph and it still vibrated. Removed the wheels ... |
10 |
