 Prev |
Professional Automotive Repair Technical Discussions for November 10, 2012 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2006 Honda Pilot EX 3.5L Timing Belt VIN: 5FNYF28656 Remove old timing belt,after installing new belt. Rear camshaft will not line up with the indicator marks. It is about two teeth off. Crankshaft, and forward shaft are lining up correctly, when I adjust the rear two teeth on the gear and tighten everything up.... |
View | |
| 2004 Nissan Titan LE 5.6L No Start VIN: 1N6AA06B54 I have a 2004 Titan 5.6L that cranks but won't start. There is no "check engine light" and I cannot communicate with the ECM. The cooling fan runs whenever the key is on. I can communicate with all other modules, and have the dreaded U1000 stored. There appea... |
View | |
| 1996 Toyota 4Runner Limited 3.4L Mechanical VIN: JT3HN87RXT Hi all, Car come for no heat and when I turn to Defog only cold air come out up there but it still on maximum heat possision. engine no over heatting! When engine up to 3000 rpm it getting warm and warmer, but not hot. We're did replace heater core,replace hea... |
View | |
| 1996 Toyota Land Cruiser 4.5L MIL Lamp on VIN: JT3HJ85J2T intermittant p0300 cannot get it to set in shop. last time customer drove 10 miles then light came back on. I suspect crank sensor or valve adjustment. engine idling vacuume reading 21" solid. snap throttle then 24" for a bit. the crank sensor wires are soak... Trouble codes: P0300 |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2009 Scion tC 2.4L Poor Idle Quality, Surge, No Acceleration VIN: JTKDE16769 Okay, thanks to everyone that responded. It really seemed that these cars don't really run into a TB issue. The fix was an intermittent open green wire at terminal 6 (the last pin on the T/B Connector. Tested for open/shorts before with none found, but when... Trouble codes: P0121 (TP Sensor Rationality). |
6 |
