Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for October 25, 2012
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2001 Chrysler Town & Country (Van) EX 3.8L HVAC head VIN: 2C8GP54L51
We have taken a two line approach to the first by chasing the draw and what circuits that are drawing. The second line was to try to chase back and see why the HVAC head does not turn off. The draw we chased back to the front control module under the driverís ...
View
1998 Dodge Caravan 3.0L all shifts VIN: 2B4FP2539W
The transmission is shifting weird in that it shifts fine if you keep your foot in it but if you back off the throttle before a shift or during a shift it acts like it binds during the shift and makes for a very harsh shift. Tryed a different solnoid pack no d...
View
1999 Dodge Ram 2500 Truck 5.9L no speedometer VIN: 3B7KF2361X
Vehicle came in with numerous problems, no shift, no speedo and oil pressure gauge drops out but oil pressure was ok. Replaced ECU and trans works ok, op gauge works for the first 5 minutes and when your driving it comes and goes. Speedometer don't work at all...
View
2000 Dodge Dakota 4.7L instrument cluster VIN: 1B7GG22N0Y
problem just started out of the blue, customer started vehicle 1 day and it would start and stall as if the theft system was engaged.also instrument cluster would not illuminate and gauges were not working.removed cluster and engine starts and runs and I can c...
View
2001 Dodge Ram 1500 Truck 5.2L front wheel bearing
The RF wheel bearing was indeed noisy and presented with outer race noisy and play in the wheel assembly. The old hub was not stuck on the steering knuckle and the new hub dropped on easily without using a hammer to seat it. Is this normal? I installed the n...
View
2007 Dodge Ram 3500 Truck ST 5.7L Mechanical VIN: 3D6WG46D57
need help have a 2007 dodge 3500 truck very low miles came in for over heat checked had bad head gaskets removed heads machine shop said heads were worped needed to be straightened installed heads after test drive no#8 cylender had missfire check intake valve ...
View
2007 Dodge Caliber SXT 2.0L No Throttle Response VIN: 1B3HB48B67
I was called to this shop to update the TCM and ECM of this vehicle per TSB#18-018-07 REV A. This bulletin addresses alot of false cam and crank codes. No problem performing the appropriate flashes with WiTech. The current ECU flash #[...] was updated to ...
View
2002 Jeep Liberty Limited 3.7L Unknown VIN: 1J4GL58K02
Thank you for reading this. This jeep came into the shop for an oil light on in dash. Diagnosed sending unit bad, replaced and oil light went out. Immediatly after this, vehicle will shift into go but will not actually go into gear, will not move in any select...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
2008 Chrysler Sebring 2.4L no shift VIN: 1C3LC45K08
Performed all the circuit test's you guys suggested. All wiring tested good. Sent to Dodge and they replaced PCM under fed emission warranty 8/80 . And we are all fixed. So PCM was the correct fix. thanks for the help guys!
13
1998 Dodge Ram 1500 Truck 5.2L Cuts out, Stall, Misfire VIN: 1B7HC16Y4W
This truck is fixed. many thanks to all IATN members for your input. Jonah from Michigan hit it on the head, bad crank sensor. truck now runs fine in reverse. no issues noted with old sensor but that was problem. joe from atlanta Trouble codes: P0320.
9
2002 Dodge Grand Caravan Sport 3.3L No Start VIN: 2B4GP44R82
Thanks to all that took the time to respond to this problem. It has been an on going project as it was a friends car and I was checking this out at home as time allowed. So I checked all wiring, harness connectors, fuse block, sensors etc. No problems found. ...
19
2005 Dodge Grand Caravan SXT 3.8L Blower VIN: 2D4GP44L55
FIX: Replace Blower Power Module with OEM part. SUMMARY: Thanks to all who replied. There seems to have been a bit of confusion about the actual symptom, so to restate: with the key ON, the HVAC system OFF, the blower would run on high. The main questio...
14
1995 Jeep Grand Cherokee Laredo 5.2L No Start VIN: 1J4GZ58YXS
thank you to all the ATN members for so many responses and yes most of you were right on the target, it was the ECM it was acting up cold,thank you
13
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next