Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for August 22, 2012
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2006 Chrysler PT Cruiser 2.4L Compressor VIN: 3A4FY48B56
Employee was using the A/C one day during the rain, shut it off because it was getting too cold and went to use it later on but the compressor would not run. A/C indicator light on dash works. Fuse is OK. Gauges indicate system has a charge. Solus tells me the...
View
2006 Chrysler PT Cruiser Touring 2.4L brake warning VIN: 3A4FY58B06
I have this PT cruiser with a brake light warning lamp constantly on non abs, ive disconnected fluid lvl sensor still stays on, disconnected the parking brake switch still stays on, I tried both at the same time still stays on, I tried a new brake fluid lvl sw...
View
1995 Dodge Dakota 3.9L 3-4 shift VIN: 1B7GG23X6S
Problem mainly after cold soak for first 10 to 15 miles. Truck is sluggish on start up, seems short of power, removed o2 sensor to check cat, no difference, when it gets to 4th gear it drops in and out of 4 th, seems to be thermally related, because after 15 m...
View
2002 Dodge Intrepid SE 2.7L Hesitation, Misfire, MIL Lamp on VIN: 2B3HD46R12
thanks for any help the problem with this car is a bad hesitation when taking off. looked at misfire data shows miss on 2-4-6 cylinders. swapped front o2 no change! what am i missing? the new o2 sensors are bosch! thanks in advance! greg Trouble codes: P0152, P0132
View
2007 Dodge Ram 3500 Truck ST 5.9L A/C compressor VIN: 3D7MX48C57
Please help I am stumped here and need to know what steps to take next! I had this truck with an inop compressor clutch which I tested and found to be a faulty clutch. Replaced compressor and sent down the road to quick lube to charge because my machine was no...
View
2008 Dodge Sprinter 2500 3.0L boost contrl VIN: WD0PE84588
I have a sprinter that is going into engine limp mode and setting a low boost pressure code 2359-001. I also have an EGR code for implausible EGR cooler temp. signal that randomly sets so I removed EGR valve cleaned and ensured proper operation,(Thought it may...
View
2009 Dodge Charger R/T 5.7L key switch
this police car is a column shift with a key start win module at times key will not go to lock so you are unable to remove key it has been to dodge dealer ,they say steering column needs replaced at a cost of 2500.00 dollars i have been able to run shifter thr...
View
2000 Jeep Cherokee Sport 4.0L Poor Idle Quality, Hesitation, Surge, Cuts out, Misfire VIN: 1J4FF48S0Y
This came from another shop that couldn't fix it. Runs bad. We have replaced the coil pack twice, crank and cam sensors once. We have synced the timing, replaced the ASD relay, replaced the oxygen sensors and finally the computer and has it programed for this ... Trouble codes: P1391 (CMP or CNK sensor intermittant), P1351 (Ign coil 1 primary circuit), P1352 (Ign coil 2 Primary circuit), P1353 (Ign coil 3Primary crcuit)
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
2008 Chrysler Sebring Touring 2.7L noise VIN: 1C3LC55R38
Customer has not returned and I have not heard anything from him sorry to report that I have not made any progress on this vehicle. Thanks for all the replies.
14
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next