Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for July 30, 2012
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
2000 Ford Windstar LX 3.8L Instrument Cluster VIN: 2FMZA5149Y
My question here today is, how do you program the anti-theft in this car with ONLY 1 KEY. There's a guy that come to my shop and can program the cluster with only only 1 key. The code that appears is "B1213 Less than 2 (or 3 if equipped w/Valet key) keys". Aft...
View
2003 Ford F-350 Super Duty XLT 6.0L cluster VIN: 1FTWW33P53
CODES p0460 fuel level sensor circuit fault p0603 internal control module kam error Memory codes u1059 scp data fault trans u1262 scp data fault for j1850 bus u1027 scp data fault for engine rpm key on engine off codes B1463 seat belt circuit open B2...
View
2003 Ford F-150 XL 4.2L Engine VIN: 1FTRX17223
I am completely stumped, any help would be greatly appreciated. I have replace motor with a used low mileage 4.2. Motor runs fine no missfires, but vibrates like a missfire from 800 rpm to 1900, then from 2200 on up. I have cleaned egr system when I replaced l...
View
2003 Ford Windstar SEL 3.8L Rear Blower Motor VIN: 2FMZA53403
Running out of options, Blower Motor runs constantly at same speed with key in or out. Installed new blower resistor but no go. Tested power and ground to relay, good and fuses to relay and toaux rear relay module. I feel like there is power bleeding over some...
View
2005 Ford Explorer XLT 4.6L No Start, long crank time VIN: 1FMDU73WX5
This vehicle is hard to start/ long crank times often. It sounds like an engine with the distributor out of time when it doesn't start- erratic boop-boop noise at tail pipe. With cam sensor unplugged it fires right up and runs perfectly, great power, nice,smoo...
View
2008 Ford F-350 Super Duty XL 6.4L push rod VIN: 1FTWW31R88
Good morning! We have a popping noise from the engine of this 6.4 Superduty. The #4 intake pushrod has bent twice in the last 30 miles! Visual inspections don't provide us with a direction. Has anyone had this problem, and found a cause? Thank you, any insight...
View
2004 Mercury Sable LS Premium 3.0L charge indicator VIN: 1MEFM55S74
vehicle came in initially with a check engine light and a check charging system light. I then pulled codes and got a PO622 - generator 'f' field control problem. Voltage and the battery while running was 12 volts. (Battery had just been on a charger) I then ju...
View

Fixes & Summaries for Ford
Fix/Summary Answers
1999 Ford Expedition Eddie Bauer 5.4L blows relief valve VIN: 1FMRU17L6X
Thanks for all the help, Especially Joe Brady, My neighbor down the street. He pursued several possible part number changes on the fan clutch for me. I got lots of oil out of the evaporator and condensor. The orfice looked ok, with just a few slivers, probably...
15
2002 Ford F-150 XL 4.2L No Start VIN: 1FTRF18262
Well another one is fixed, after following the trouble trees to a dead end, I started over. I assumed the new transceiver was good, and the code was a false one, so I had two new keys made, erased the program and programed them, still no start. With the clus... Trouble codes: B2103 (Atenna not connected faulty transceiver), B1600 (PATS transponder signal not received), B1681 (PATS transceiver module signal is not received).
8
2001 Mercury Cougar 2.5L Mechanical VIN: 1ZWFT61L81
Thanks for all the help IACV fixed it.Cleaning the intake and all the valves help but the IACV was the fix in the end Thank you
8
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next