|Prev||Professional Automotive Repair Technical Discussions for May 20, 2012
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|2002 Toyota Camry SE 2.4L engine VIN: JTDBE32K32
fist off, she ran it low on oil. put some oil in and brought it to me. i did an oil change, no noise. claims an half hour after she left this engine has a whine type noise from engine. cold or hot. has to be above 1100 rpm. removed belt and is still there. rem...
Fixes & Summaries for Asian
|2004 Lexus RX330 3.3L heater core VIN: JTJGA31UX4
Hello all, Thanks for all the help! The problem with this vehicle turned out to be the drain pan for the evaporator condenser being clogged up and not a failed heater core. The wetness on the floor was just clear water not being able to drain from the drain pa...
|2008 Mazda 3 S 2.3L Hesitation VIN: JM1BK32378
Thanks to all who replied. The crank pulley was removed when the engine was installed. After following the proper timing procedure, the car runs great. Thanks again for the help, Steve
|2000 Nissan Sentra GXE 1.8L Ignition VIN: 3N1CB51D6Y
Hello folks! I decided to close this help request due to the following: the car is not complete fixed yet and seems it will take a little longer for them to decide if go for a new computer or for a used one. Every one of you, gave me a good tip about the root ...