|Prev||Professional Automotive Repair Technical Discussions for October 28, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1982 American Motors Eagle Limited 4.2L starter VIN: 2CCCK3872C
Car came to us 8K miles ago with a very noisy starter, like misaligned, wrong depth, or mismatched numer of teeth. Customer says starter and ring gear replaced 4 years ago, but was not this noisy when he picked it up from them. We inspected ring gear for damag...
|2005 Chrysler Crossfire 3.2L MIL Lamp on VIN: 1C3AN65L65
DTCs rich bank 1 and 2, Long term fuel trim is at around -25% @ idle banks one and two. While driving heavy accell can recover to -14% but goes right back up to -25% at idle. cruising speeds normal throttle does nothing to LTFT. Using generic OBD2 to diag as L... Trouble codes: P0172 (Rich bank 1), P0175 (Rich bank 2)
|2000 Dodge Durango 4.7L Abs Module VIN: 1B4HS28N5Y
This vehicle came in with abs pump running all the time even with the ignition off.we get a used abs module and tryed still doing the same .we check grounds .power from ignition switch goes out when turn off .i'm thinking that i have a defect one
|2003 Dodge Ram 1500 Truck 5.7L tcm VIN: 1D7HU18D33
Truck came in last week with no communication with TCM and in limp home mode. Did some pin out test and it led us to replace the TCM. After replacing the TCM It will intermittently communicate. When it does the PRND21 is lit up. Other wise it is not. If you mo...
Fixes & Summaries for Chrysler
|2002 Chrysler Voyager 3.3L Solenoid pack VIN: 1C8GHB5R72
Thanks to everyone, the consensus was pretty clear so a new updated solenoid pack and gasket was fitted and so far so good, our supplier also suggested we may need to fit a check valve to cooler return hose to help with a possible drain back problem due to int...
|2004 Dodge Intrepid SE 2.7L Pcm VIN: 2B3HD46R34
Cory from Kansas was the closest (although I didn't read his post until after I had it fixed). I got me a good Mitchell wiring diagram and proceeded to trace the sensor wires. I started with the crank sensor; I verified a 5v power and a good ground. Next I ...