|Prev||Professional Automotive Repair Technical Discussions for July 13, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1999 Chrysler Intrepid 2.7L Blend Door VIN: 2C3HH46R0X
This vehicle has been here several times and now has a fault of no blend door operation. It will only dirrect the air to defrost or floor mode. It seems to bypass the vent mode. I can see the arm moving for the mode/blend door but no air comes from the vents. ...
|2002 Chrysler Sebring Limited 2.7L timing chain VIN: 1C3EL65R02
Hey guys, need help/advice again. We replaced the water pump on 2.7, put back together and it runs great and leak is repaired. We now have lots of timing chain noise/rattle. This is our first one and are finding out from others that these are a bear. Good cust...
|2000 Dodge Grand Caravan 3.0L Belt VIN: 2B4GP4433Y
For about a year now we have been trying to get this van to stop eating belts. The belt will go on fine and run with no problem. Then it will start riding on the outside edge of the pulleys. It doesn't take long then the belt will get chewed up and break. So f...
|2006 Dodge Magnum SE 2.7L Engine VIN: 2D4FV47T96
This vichle has came in a few times with coustmer complant of whistle noise from engine compartment. It sounds like its comming from intake we replaced the upper intake manaifold. It still makes the noise it only happens after driving for awile and we have not...
|1997 Eagle Talon 2.0L MIL Lamp on VIN: 4E3AK24Y8V
Hello, sorry but this one may be lacking in some information but to be honest there is not a lot I have done due to the fact that this car has no plates on it, it is here from another shop looking for help on it. The vehicle runs fine every time we run it, and... Trouble codes: P0300 (Multiple cyl misfire), P0301 (Misfire cyl 1), P0302 (Misfire cyl 2), P0303 (Misfire cyl 3), P0304 (Misfire cyl 4)
Fixes & Summaries for Chrysler
|1988 Chrysler New Yorker Landau 3.0L Cuts out, Stall VIN: 1C3BU6634J
Well I thought we had this fixed. I dead headed the pump as someone suggested, but that didn't change anything. I looked at the O2 sensor, as another person suggested, but I never saw it go at or above 1V. However, the O2 sensor was switching rapidly, excep...
|2002 Dodge Ram 1500 Truck 4.7L cooling system VIN: 3D7HA18N02
Thanks to everyone who replied. Almost everyone suggested the radiator and that was it. I suspected it but couldn't understand how it could have caused a sudden and continual overheat. The heater core is also clogged but he will live without heat for now. O...
|2003 Dodge Intrepid SE 2.7L Exterior Lamps VIN: 2B3HD4R23H
Thanks to all who took the time to reply to my help request! I am very happy to say I (we) have fixed this car. I didn't realize the BCM goes to default if the headlamp switch is disconnected. A special thanks to Jonathan from Utah! I ordered a new switch (#46...
|2009 Dodge Caliber SXT 2.0L Hesitation, Low Power VIN: 1B3HB48A59
Well I stretched this as long as I could. We were able to get the vehicle to act up. The PCM was off line. NO communication per Wi-Tech. We checked connections but found no problems. Because the PCM was under warranty we sent the vehicle to the local Chrysler... Trouble codes: U0001 (CAN C Bus), U0402 (Implausible Data), P0481 (Cooling Fan Control 2), P0480 (Cooling Fan Control 1), P0463 (Fuel Level Sensor 1).
|1999 Jeep Grand Cherokee Laredo 4.7L Instrument Cluster VIN: 1J4GW68N3X
Well the vehicle has been gone for over a week and I have not heard back from them so I will call this one fixed. Thanks for the great replies. There ended up being 2 problems. Out of desperation I tried a used BCM and the door lock and window issues went a...