 Prev |
Professional Automotive Repair Technical Discussions for November 26, 2010 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1996 Ford F-350 XLT 7.3L Cuts out, Stall VIN: 1FTJW35F7T Okay Powerstroke techs need some help. I have replaced the cam sensor swapped the idm with a known good part. Checked and have the ground, 5 volts and 12 volts at sensor. Truck will start bucking and die and will usually restart with no porblems and gives the ... Trouble codes: P0344 |
View | |
| 1998 Ford Econoline Super Duty Custom 7.3L Hesitation, Surge, Cuts out, Misfire VIN: 1FDXE40F1W hi guys fist time posting for help so here goes. ive got this shuttle bus that missfires really bad under load. runs really rich. the exhaust pressure butterfly dosn't close always open when driving, turbo isnt spooling. ran koer test sets p0476 everytime. whe... Trouble codes: P0476 |
View | |
| 1999 Mercury Sable LS 3.0L Heater temp VIN: 1MEFM58U4X Car arrived with a no heat condition. A/C cycles continuously, even when only heater is on. Found Temp Actuator motor to be faulty- replaced it. I thought that was the end of the problem...but nooooo. reads about 100 in shop & about 75 on the road on a 40 degr... |
View | |
| 2004 Mercury Grand Marquis GS 4.6L 3-4 shift none VIN: 2MEHM75W24 We have this Merc from a used car lot we deal with we dont do trans work so we need some help as soon as trans comes out of second gear the rpms just redline 1-2 seem fine no codes other than po1270 rpms over revving da! My quetions are what pressure voltage s... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2001 Ford Mustang 3.8L Surge, Cuts out VIN: I DON, thank to everyone the spend time enswering my help ,it end up being the crank sensor the waveform on scope was just a bit up and down after 3k rpm just enogh to cause trouble.thank you again,iatn is a great team. |
11 |
