|Prev||Professional Automotive Repair Technical Discussions for November 26, 2010
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1993 Jeep Grand Cherokee 5.2L No Start VIN: 1J8HR48N45
I have a 1993 zj with a 5.2 that has a starting problem. I've done a search and found a few posts of similar problems, but none with a fix. When you first turn the key on, the rig will not start. No MIL, no spark, no injector pulse, no fuel pump, no asd relay,...
Fixes & Summaries for Chrysler
|1999 Chrysler Sebring JXi 2.5L Excessive Emissions, Poor Idle Quality, Surge, Cuts out, Misfire, MIL Lamp on VIN: 3C3EL55H9X
Thanks to all who replied. Those of you that suggested the distributor was the problem were spot on! However I would like to suggest you sell the customer new spark plug wires when replacing the distributor. The stronger coil in the replacement distributor wil... Trouble codes: P0300 (Random misfire), P0302 (Misfire cyl 2), P0305 (Misfire cly5).
|2001 Dodge Caravan SE 2.4L Right Low Headlight VIN: 1B4GP25B11
WOW! Thanks for all the replies! I wouldn't have believed it if I had not have had it happen to me. The fix is... Weld the broken frame up!!! The front radiator frame support on the right side is only tacked together, and came apart falling on the wires for...
|1991 Jeep Cherokee Limited 4.0L No Start
Sorry but I have not fixed this Jeep yet, Most said check timing, check water in fuel, check exhaust for being plugged, I checked cranking vaccum by putting my hand over throttle body and it sucks my hand right down, I checked fuel quality and it is ok, I have...
|1996 Jeep Cherokee Country 4.0L fuse # 20 30amp keeps blowing VIN: 1J4FJ78S5T
I love clicking the Yes I have fixed the vechicle tab!!! Thank you all who responded. Most responded with downstream o2 rubbing on drive shaft. That was close. What I found was the upstream o2 sensor wiring rubbing against the exhaust manifold. The inuslation ...