|Prev||Professional Automotive Repair Technical Discussions for November 20, 2010
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1999 Dodge Ram 1500 Truck 5.9L brake lights VIN: 3B7HC12Y7X
the brake lights on this thing are always on when you turn the key on, they work normally key off, the white/tan wire off of the breke light switch is powered even with it unplugged, unplugged combi switch same thing, unplugged the comb connector under dash an...
|2004 Dodge Ram 1500 Truck SLT 5.7L Poor Idle Quality, Stall, MIL Lamp on VIN: 1D3HA14J19
hi all,wondering if anyone out there has run into this before. this ram truck will not stay running. as stated,has codes for both cam and crank sensors,replaced both sensors with no change. truck cam in 3 quarts low on oil and has been 7,000mi. since last oil ... Trouble codes: P0335 (crank sensor fault), P0340 (cam sensor fault)
|2004 Dodge Sprinter 2500 2.7L compression VIN: WD2PD64384
Hello Techs, This vehicle was towed in for crank no start. While cranking the exhaust smokes black soot, covers the ground like sand. Scanned ecm and only pulled EGR code(p2527). scanned data and saw injector rail pressure over 5000 psi. MAF did show reading, ...
Fixes & Summaries for Chrysler
|2004 Chrysler Town & Country (Van) Limited 3.8L headlamps VIN: 2C8GT64L74
THe front control module is mounted on the front of the ipm or fuse box, all connections loook good, and old fashioned wack exposed the problem. Thanks to those who actually helped, no thanks to those who replied so that they were allow to post their request.