 Prev |
Professional Automotive Repair Technical Discussions for October 7, 2010 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2004 Chrysler Sebring 2.4L Poor Idle Quality, Stall VIN: 1CREL46X14 HAs anyone come across this problem. Vehicle runs fine under load, but when hot, every time you release the throttle at idle the vehicle stalls, starts right up and stalls again. thanks for the help Trouble codes: P0172 |
View | |
| 2004 Chrysler Sebring 2.4L No Start VIN: 1C3EL55R14 A customer of mine had 2 2004 Chryslers, one had SKIM the other did not. He put the non-SKIM PCM in the SKIM car then swapped it back to it's original car (non-SKIM). The PCM that once thought is was non-SKIM and the car started now thinks it has SKIM and wo... Trouble codes: P0633 (SKIM code not programmed in PCM) |
View | |
| 2006 Chrysler PT Cruiser 2.4L MIL Lamp on VIN: 3A8FY68856 Hi all thanks for the help in advance this pt loser is giving me some problem.car came in with a multi cyl misfire. We felt it was tune up time customer stated they had never done anything except oil changes.we replaced plugs and wires with oe.cleared codes an... Trouble codes: P0304 |
View | |
| 1999 Dodge Ram 2500 5.9L starter VIN: 1B7KC2368X after charging system,tried to start,starter sounds like it is dragging. put vehicle on lift,installed new starter, still same noise...remember this engine has low miles for a diesel...how can i check the engine to see if it is ok? turned crank to see if it wo... |
View | |
| 2002 Dodge Durango SLT 4.7L MIL Lamp on VIN: 1B4HS58N42 hi guys i have this 4.7 L with loss of crank and cam signal. don't know much history on this truck. it was bought from auction by the used car dealer.had missfire rocker was off. we put the rocker back in and it ran good. had PCM internal failure fault set. we... Trouble codes: P1391 |
View | |
| 2004 Dodge Sprinter 2500 2.7L Ecm VIN: WD2PD744X4 Truck came in originally on a hook, driver shut off and had nothing when key was turned to the crank position. Found ECM relay in center position of fuse block on colum inop. Put a new relay in and it fired right up. Same thing happened again a few days late... |
View | |
| 2005 Dodge Durango Limited 5.7L cruise control VIN: 1D4HB58D15 Hello and thanks in advance. this durango came in last week for a stalling problem. never got it to act up, but found updates for pcm. performed the refash, all went good cust not eexperiencing stalling but now cruise is inop, you can set the light at idle, it... |
View | |
| 1997 Jeep Grand Cherokee Laredo 4.0L 4 Wheel Drive VIN: IJ4GZ5852V This jeep came to me with the rear diff. Bearings out i replaced them and not it seams like it in in 4wd all the time. The stick shows 2wd but it jumps when you turn sharp. It also has a loud roaring noise when driving. I took the front driveshaft out and it s... |
View | |
| 2000 Jeep Grand Cherokee Limited 4.0L Starter VIN: 1J46W48SXY Vehicle is a no crank. Can jumper at relay and will start fine. Also will start if I probe yellow wire with test light to ground, in ignition switch harness, key in on position. Terminal 86 at starter relay is hot at all times and should be hot only in start p... |
View | |
| 2002 Jeep Grand Cherokee Laredo 4.0L Oil Gauge VIN: 1J4GX48S52 Has low oil pressure @idle and pumps up @freeway speeds, no engine noise. Looking for a way to test the pump and possible cam bearings(read a few posts about cam walking). Any way to test these two systems without a lot of time? thanks in advance for your repl... |
View | |
| 2002 Jeep Grand Cherokee Laredo 4.0L MIL Lamp on VIN: 1J4GX48S92 This poor jeep keeps setting this code. We can start it cold and within a couple minutes, it sets p0135. The voltage is dropping below 3 volts within 75 seconds like the test says, so its hard to understand why it keeps saying there is a problem when the volta... Trouble codes: P0135 (1/1 o2 sensor heater failure) |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2002 Dodge Caravan SE 3.3L Paint Blisters VIN: 1B4GP25R02 Using food coloring placed on rags both in the fuel door area and the wheel well, water was entering through the pinch weld beteen the inner wheel well and the outer quarter pannel. The water has been causing the blistering in the same location because a reinf... |
5 | |
| 2004 Dodge Ram 1500 SLT 5.7L tracking VIN: D7H418D64J Okay thanks for all the help. We eliminated any brake issus and gave all bushings in the front end a real good 20/20. We replaced the front tires and had a four wheel aligment done at a local shop and it drives just fine now. Thanks again Stephen |
16 | |
| 2004 Dodge Ram 1500 SLT 5.7L Filled with Kerosene VIN: 1D74A18D74 Thanks everyone for all the help! Broken valve springs, bent valves...Jasper motor will be here monday! |
21 | |
| 2005 Dodge Ram 1500 SLT 5.7L low comp VIN: 1D7HU18DX5 used camera done cylinders and found scorn cylinders truck had gone 15000 miles over oil change and oil was 4qts low |
7 | |
| 1999 Jeep Cherokee Sport 4.0L Misfire VIN: 1J4F67S7XL rodrigo from ill was on target with the 02 sensor I found after further inspection of the o2 sensors that my front Bank 1 Sensor 1 was acting up It never set a code for misfire but was the cause of this misfire thank to everybody who offered help |
28 | |
| 2007 Jeep Liberty Limited 3.7L Hesitation, Cuts out, MIL Lamp on VIN: 1J8GL48K67 Thank you for your input. I did have to spend some time and a little heartache with this one, but it turned out well. Got it figured out and returned to the customer. The actual cause was fuel. Looking at it and smelling it, there were mixed opinions here abou... Trouble codes: P0171 (Fuel system 1/1 lean), P0174 (Fuel system 2/1 lean). |
4 |
