|Prev||Professional Automotive Repair Technical Discussions for August 15, 2010
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1993 Dodge D250 5.9L a/c alt speedo
No a/c ,no alt,no speedo,no communication to scanner. Ground a/c relay & clutch works,ground other relay & alt works.Crank sensor checks ok,replaced ign switch.checked all fuse links.Suspect pcm . No wiring diagram. anyone know which pins at pcm to verify it"s...
|2004 Dodge Ram 3500 Truck SLT 5.9L Poor Idle Quality, Cuts out, Stall VIN: 3D7MU48C14
Truck towed in idle will drop to 500 and almost stall engine will catch stall and idle jumps to 1500 then down to 800. Fuel pressure on scan tool will drop 2000 psi or more below fuel pressure set point with a drop in idle speed, then if it don't stall pressur...
Fixes & Summaries for Chrysler
|2000 Dodge Ram 2500 Truck 5.9L Cuts out, Stall VIN: 1B7KF236XY
After a few days of using this vehicle on and off, the hot soak problem persisted. The diagnostic code never reset, and the shut off solenoid seemed to be working normally. Customer agreed to replace the VP44 injector pump. Since replacement of the pump, th... Trouble codes: P0370 (Injector pump speed sensor signal loss).
|1998 Jeep Grand Cherokee Limited 5.2L Misfire VIN: 1J4GZ58Y8W
Once again, thank you to all memebers who responded. Alot of great ideas. What really ended up fixing this was going back to the beginning. As I said in my original post, when I moved the injectors from #3 to #1 and # 6 to #8 the misfires also moved.What I did...