× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for June 12, 2010
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1994 Dodge Grand Caravan SE 3.3L No Start VIN: 2B4GH2531R
Van would not start after shut off. Testing found no spark, followed flow chart for code ll, and replaced ecm due to no 9 volt feed to distributor. New ecm installed and still no 9 volt feed. I checked 12 volt ign. switch feed to ecm and load tested it. It tes... Trouble codes: 11 (no crank signal received at ecm)
View
1995 Dodge Grand Caravan SE 3.3L Poor Idle Quality, Surge, Stall VIN: 1B4GH44R4R
I replaced crank sensor with oe part. Now vehicle will start and idle fine, but intermittently surge and stall. I don't have a scope, but my fluke 215 shows good ac voltage from cam/crank sensors around 500mv until after engine stalls. Testing map sensor and... Trouble codes: 13 (No change in map voltage)
View
1995 Jeep Grand Cherokee Laredo 4.0L Stall VIN: 1J4G25856T
this is my senior neighbors truck. she has had it quit running three times on her while driving. it will restart after each stall after approx 5 minutes. no codes are present and all sensors seem to display normal values when scanned. fuel pressure is 50 psi@ ...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
2000 Chrysler Voyager 2.4L Cluster VIN: 2B4FP25B2Y
sorry for the delay cause the bcm is or was on back order.the bcm was bad and also the cluster board replaced both yesterday and she fired rite up no problem.
4
2001 Chrysler Sebring LX 2.7L No Start VIN: 1C3EL45U91
the problem was the pcm. we replaced the pcm and the car starts up everytime now. when the car wouldn't start, I continually had good power and ground to the pcm but the PCI Bus messaging went flatline coming out of the pcm. I had cut the PCI network wire (yel...
7
2002 Chrysler Concorde Limited 3.5L Starting VIN: 2C3HD53G72
I want to thank everybody for there replies. Checked out every thing to the starter which has 12 volts to it so it should have started. So I am in agreement with those that said that it was the security system. I called our local dealer to see what they would ...
17
2005 Jeep Wrangler Sport 4.0L MIL Lamp on VIN: 1J4FA49S85
This Jeep has a TSB to reflash the PCM do to this code thanks to all that replied. check out my web site to see my video on the Worlds Quickest Cherokee www.blairsautocare.com Trouble codes: P2096 (Bank 2 lean).
7
1998 Plymouth Voyager 3.3L No Start VIN: 2P4GP45R4W
Thanks again to IATN - especially to those who posted their helpful thoughts. When this vehicle is working fine it is difficult to diagnose. It happened that the vehicle would not start this morning. I noticed that the odometer and PRndl display and the fuel g...
8
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next