Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for February 13, 2010
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1984 Ford Bronco II XLT 2.8L thermostat VIN: 1FMCU14SXE
This vehicle takes forever to stabalize the temp. It will climb to 3/4 scale and then drop to below cold several times. after about 7 miles it will almost be normal and stable. I went back into the thermostat thinking it was faulty, but I am starting to think ...
2000 Ford Explorer XLT 4.0L tcc VIN: 1FA51UWAR1
Changed engine,every thing was fine,cust returned two days latter,od light flasing,p0741,monitored tcc gets to 98% then goes to zero and od light flashes.Is there something in changing the engine that could cause this.
2000 Ford Taurus SE 2-Valve 3.0L Surge VIN: 1FAFP5527Y
i got the car from a other shop were most of the parts were replaced. i found the wrong plugs were installed and the wrong gap was set, there was also a cracked spark plug. i installed the correct plugs with the correct gap. i also found the cracked pcv hose a... Trouble codes: P1137 (ho2s12 indicates lean), P1157 (ho2s22 indacates lean), P1131, P1151
2002 Ford Expedition XLT 5.4L oiling VIN: 5678567856
I have a ford 5.4 motor that has been neglected in its oil changes, the inside of the valve covers, heads, oil pan, and timing cover are caked with sludge. This is by far the worst one I have seen. The engine runs very well but has worn timing guides which are...
2003 Ford F-350 Super Duty XL 6.0L Stall VIN: 1FTNX21P03
any 6.0 techs out there today?this one lost power,died wont fuel filters,plenty of fuel,no crud in fuel module.this is where i need help,icp is low,had some inj.orings leaking replaced them,same icp.[data screen shows pressure at 300-400psi,takes 5...
2003 Ford Ranger XL 3.0L No Start VIN: 1FTYR14U13
I'm stumped on this 2003 Ford Ranger no start condition. 3.0L V6 died on the customer while driving.crank and cam sensors where replaced by the customer before we saw it. I've confirmed crank and cam sensor signals to the ECM are good. cam sensor is synced. Al...
2003 Ford Excursion Eddie Bauer 6.0L Hesitation, Surge, Cuts out VIN: 1FMSU45P53
cant go over 2000 rpm or full throttle. ok as you can see ive done some stuff to this i took apart the turbo and cleaned it i can now with back probing into the ebp sensor i can watch the vtg% increase and see the back pressure volts go up and vice versa at an... Trouble codes: P2263

Fixes & Summaries for Ford
Fix/Summary Answers
1998 Ford Expedition XLT 5.4L Suspension VIN: 5678785677
thanx for the replies.did a bunch of research for the original airshocks were made by monroe pn on the monroe website and found the build specs asfar as length extended and collaped and travel of the unit.went through the entire line and came up with...
2002 Ford E-350 Econoline 5.4L Cooling Systems VIN: 52D12DDF22
Thanks to all I installed new connector and ect sensor flushed system and turned it loose -- to be continued customer is very patient and cool,, Ill update when i get more info thanks again
2006 Ford Expedition XLT 5.4L Excessive Emissions, Poor Idle Quality, Surge, Misfire, MIL Lamp on VIN: 1FMPU16506
Hi! This finer ford is being sent back to it's maker and yes i take this too personally!! I would like to thank those who responded and will keep you posted when the Ford Gods have determined the problem and solution, which is certain to be something simple... Trouble codes: P0011 (Intake Cam Pos. Timing Over advanced), P0022 (Intake C. P. Timing Over retarded), P0305, 7, 8 (Misfire Cylinders 5 7 8), P2198.
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next