|Prev||Professional Automotive Repair Technical Discussions for November 14, 2009
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1999 Ford Expedition XLT 5.4L istrument panel/radio VIN: 1FMPU18L6X
car came in with battery light on and odometer and washer light and 4x4 light flashing along with radio inop while in reverse and drive seems fine in park seem to be a short but i cannot find it any help would be helpfull thanks in advance.
|2002 Ford Ranger Edge 4.0L Hesitation, Cuts out, MIL Lamp on VIN: 1FTZR45E12
Hi everybody and thanks in advance for your help. This vehicle idles OK but when accelerate sputters, hesitates and fuel trims go up to -23 B1 and -20 B2 MAF 54.26 gm/s with 2.88 V. and the codes listed below. I installed a NAPA MAF sensor, no change, found fu... Trouble codes: P1100 (MAF Sensor intermitent), P0171 (Lean Bank 1), P0174 (Lean Bank 2)
|2003 Ford Expedition XLT 5.4L ins. panel, VIN: 1FMFPU16L9
Hi guys, The customer dropped this one off to me. (drove in) He told me that one time he was driving down a gravel road and the guages just stopped working, then he came to a stop, put the vehicle in park, then attempted to go again and could not get vehicle o...
|2002 Mercury Mountaineer 4.0L No Communication VIN: 4M2ZU86E32
Hi Group! This Mountaineer failed Mass state inspection due to NO COMMUNICATION with PCM. I have checked that we have B+ at pin 16 of ALDL. Also good ground at pins 4 and 5. I checked continuity from ALDL to PCM on pins 2/10/13 and all is good. The only othe...
Fixes & Summaries for Ford
|1997 Ford F-150 4.6L arching electrical VIN: 1FTDX1868V
Ok, I forgot to mention that the belt was also replaced with the pulley, this is my first help request, I'll do better next time with the info. The vehicle was there waiting for me this morning for the new pulley. I decided I wanted to solve the problem before...