Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for October 29, 2009
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1985 Chrysler LeBaron 2.2L Hesitation, Cuts out, Stall VIN: 1C3BC56D1F
I've got one here that is putting me to the test. This Lebaron was brought to me with the complaint of poor acceleration and stalling. I road tested vehicle and sure enough, I confirmed the complaint. I found that the vehicle accelerated faily well when I star...
2004 Chrysler Town & Country (Van) LX 3.3L abs VIN: 2C4GP44R44
Hello, I am having some problems repairing the Abs on this van. Van came in yesterday with one code LF wheel Speed sensor failure, Ohmed out sensor and found to be open. Replaced and went to clear codes, One more code showed up for the LR signal failure. Ok so...
1998 Dodge Grand Caravan SE 3.3L Safety VIN: 2B4GP44G0W
Help Chrysler Techs! Our Chrysler Tech is off and our Honda Tech has replaced the blend door motor and e-brake pedal assembly on this van and now we have an air bag fault "loss of ign run only" in air bag system and no power to the # 1 fuse for the air bag in ...
2000 Dodge Ram 2500 Van 5.9L check engine light VIN: 2B5WB25Z1Y
vehicle came in shop with check engine light on codes po753, po765, po743. found electrical connector for transmission damaged, replaced with one from chrysler. same codes so I replaced the 3-4 solenoid assembly because it was slightly out of specs, same probl...
2001 Dodge Ram 1500 Van 5.2L No Start VIN: 2B7HB11Y91
I need some help with theroy and operation on this vehicle please. Van towed in with a no start and no bus on the display. I cannot communicate with the pcm. If I manually trigger the ASD relay the Van starts and runs perfectly and I can communicate with all m...
2001 Dodge Ram 2500 Truck 5.9L ride control VIN: 3B7KF23Z11
hello. thank you for your time. we installed four new tires on this 2500 dodge 4x4. a few days later he returned saying his vehicle shakes. test drove the vehicle. didn't really feel a shake, but reblanced the tires. he came back and said the shake was still t...
2003 Dodge Ram 3500 Truck 5.9L No Start VIN: 3D7MU48C23
Hi all - this truck came in last night and died at our door. it was low on fuel so we added 10 gal - didn't start - cleaned battery cable ends - changed fuel filter - took fuel sample - checked air filter - sat for about an hour and started up- would not start... Trouble codes: P0628, P0633
2003 Dodge Neon SE 2.0L Cuts out VIN: 1B3ES26C43
this vehicle sets code p2053 after approx 1.5hr of driving stop and go on moderate to hard acceleration or if vehicle sets running at bus stop for long periods of time. I fell no miss then pcm shuts off #2,3 injector, activates light and engine runs on two cyl... Trouble codes: P2305
2003 Dodge Ram 2500 Truck 5.9L Electronic VIN: 3D7KU28683
cust.states all warning lights on in cluster and fuse#3 keeps blowing[30amp maxi].we confirmed all mils on,both brake/abs,airbag,cel.cust also states speedo inop.replaced fuse#3[hasnt blown since].scanned ecm found p0500 no speedo signal and codes for cooling ...
1997 Jeep Grand Cherokee Limited 4.0L Cuts out, Stall VIN: 1J4GZ78S7V
I am involved and in deep in this Jeep. It intermittently will cut out most often on decell then sometimes backfire as you crank it. May start right up. Have verified good cam and crank patterns with DSO at PCM. Also battery power to coil does not change. PCM ... Trouble codes: P0351 (Ignition coil primary circuit)
2002 Jeep Grand Cherokee Limited 4.7L azc VIN: 1J8GW58J32
Hello all and thanks in advance for help. This 02 Jeep has no heat (automatic temp. control), lowered glove box door to see RH blend actuator, does not move at all with dial movement. Disconnected battery, system goes through initialization (actuator rotates),...
2002 Jeep Grand Cherokee Limited 4.0L chugs VIN: 1J4GW48S62
the vehicle is chugging. it does it whether its hot or cold. when you put the vehicle in drive with your foot on the brake and then slowly ease off the brake pedal it starts chugging real hard. the weird thing is it idles fine and runs great at any other speed...
2003 Jeep Grand Cherokee Limited 4.7L assist VIN: 1J8GW58N23
vehicle came in a few months back with noise and no assist, found hi pressure line to be leaking, replaced, found pump to be bad, replaced. vehicle left with good assist. vehicle just returned to shop, no assist, performed flow and pressure check and found app...

Fixes & Summaries for Chrysler
Fix/Summary Answers
2004 Chrysler Pacifica 3.5L MIL Lamp on VIN: 2C8GF68404
Customer had filled up with gas the day after i fixed it and did not get the new cap tightened enough. Mike [...]
2006 Chrysler Town & Country (Van) 3.3L Hesitation, MIL Lamp on VIN: 2A4GP44R66
rechecked fuel pressure after aftermarket fuel pump,found low.replaced fuel pump module from dealer.fuel pressure in spec.runs great,fuel trims good.suspect faulty pressure regulator.for the record,the factory part pump with regulator and fuel level sender was... Trouble codes: P0171.
2006 Chrysler Town & Country (Van) LX 3.3L Lighting VIN: 2A4GP44R06
Problem was bad headlight switch. We had specs on the signal to BCM wire from the switch for park and headlight position (2.4V park, 1.5V HDLT) which was good, but nothing for the lights off signal. We were getting a 4V signal to BCM from the switch in the off...
2001 Dodge Grand Caravan SE 3.3L monitors VIN: 1B4GP25351
Fixed might be too strong a word. On the seventh drive cycle, we were finally able to get all but one monitor to successfully run and "stick" (stay complete). I want to clarify the original post for some of the respondents. The PCM was correct. The re-flash ...
1994 Jeep Grand Cherokee Laredo 4.0L No Start VIN: 1J4G258S5R
thanks for all your help...this one ended up having a bad connection at the auto shut down relay...i took the power dist box apart and cleaned all the termianls and all is good...thanks again! Trouble codes: 54 (no cam sync signal at pcm).
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next