 Prev |
Professional Automotive Repair Technical Discussions for August 28, 2009 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 1993 Chrysler Town & Country 3.3L No Start, Cuts out, Stall, MIL Lamp on VIN: 1C4GP54R9V This T&C will go into theft mode very intermittently. The last time the vehicle went on a 500 mile ride was parked and would not start and stay running after that. It would start then quit because of antitheft shut down of injectors. I found that there was fro... Trouble codes: P1695 (lost communication with bcm) |
View | |
| 2001 Dodge Durango 4.7L no communication VIN: 1B4HR28N51 durango was brought to me with no start condition, cranks ok. initial inspection was no bus messege in instrument cluster and horn and lights were going off intermittently. i hooked my modis to the dlc and could not communicate with pcm. also BUS was tested an... |
View | |
| 2001 Dodge Intrepid SE 2.7L No Start VIN: 2B3HD46RX1 Hi everyone & thanks in advance for any & all help that you can give me. I'm at a loss on this one. This car came in our shop starting & running fine but needed an engine because the customer ran it dry of oil, so when it got hot had low oil pressure with a c... |
View | |
| 2003 Jeep Liberty Limited 3.7L ABS light VIN: 1J4GL58K03 Hi Everyone and thanks for reading. Customer complaint ABS light on. NOTE this vehicle is not equipped with ABS. I realized this later on. ABS light does a bulb check and goes out at start up. Approximately 6 seconds later comes back on steady. Check for co... |
View | |
| 2005 Jeep Wrangler Rubicon 4.0L No Start, MIL Lamp on VIN: 1J4FA64S25 I have a 2005 Jeep Wrangler Rubicon wita a 4.0L and a manual transmission.. This vehicle will not start or run and the starter relay will not send a signal to the starter solenoid and the fuel pump relay and asd relay will click irratically but not stay on. Wh... |
View | |
| 1999 Plymouth Voyager 3.0L compressor VIN: 2P4F92537X vehicle had comp. locking up, replaced a/c compressor, drier, h-block, and flushed the system. recharged with 134a freon, a/c system cooling great, till you go drive vehicle on a hot day and get over 55 mph a/c will shut off briefly let off accel. to slow down... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2005 Chrysler 300 2.7L rough, lacking power VIN: 2C3JA43R95 I drove this car several times over a two day period for a total of 80 miles. The problem never occurred. I monitored my scanner during the road testing. It never showed a misfire, fuel trim always was verying less than two percent. O2 sensor operation looked ... |
3 | |
| 2001 Dodge Ram 2500 Van 5.2L No Start VIN: 2B7JB21Y31 As I suspected and some of the replies confirmed the driver in the new PCM was gone again. The coil on the vehicle was only a month old but I should of replaced it anyway. Our rebuilder was good enough to replace the coil driver for us so it didn't cost us a... Trouble codes: P0351. |
6 | |
| 2005 Dodge Grand Caravan SXT 3.3L No Start, Cuts out, Misfire VIN: 1D4GP45R95 Thanks to Shawn and Marc for getting me going in the correct direction. It ended up being the signal wire from the crank sensor to pcm. The wire was below the battery and it was swollen but not broken. I did check the wires by the coil and they were perfect, T... Trouble codes: P0335 (crankshaft sensor signal), P0129 (Baro reading out of range). |
4 | |
| 1993 Jeep Grand Cherokee Limited 4.0L No Start, Stall VIN: 1J4GZ78S0P thank you for all of the replies. i was unable to find the resistor needed to prevent coil burn out. i installed new ignition wires, cap and rotor, along with a new ignition switch just for kicks. vehicle still stalls intermitently but always restarts. custome... |
7 | |
| 1997 Jeep Wrangler SE 2.5L coolant temp gauge VIN: 1J4FY29P5V I wanted to wait a little while before closing this request as the jeep is not a daily driver. So far no other problems have surfaced. The Jeep was not overheating, but the customer was worried when the gauge shot to HOT. Evidently my Vantage Pro is more sensi... |
5 |
