|
|
1999 Chrysler Town & Country 3.8L no start
This van was towed in as a no start from a GM dealer that
sends us all their non GM cars. The dash was half apart.
Can't get a straight story on the original symptom. Owner
says all parts are original, but I am concerned they are
not being truthful about the B... |
View |
|
2006 Chrysler Town & Country 3.8L left front rotor/caliper
We have seen this recently on two different Chrysler
minivans. The first one was a 2001 and the customer wasn't
happy over the 6 months of trying to catch the problem.
Both customers complained of a burning smell and loss of
power and vibration. It was hard to... |
View |
|
1995 Dodge Dakota 5.2L emission
car came in 1/5/05 for failed smog and a brake job.
replaced egr valve and oxygen sensor and car passed. also
replaced thromostat. car came in a few days ago for failed
smog also. readings failed for hc and nox. nox measure 734
and max was 508, hc mease 93 at ... |
View |
|
2000 Dodge Grand Caravan 3.0L compressor & cooling fans
Customer brought vehicle in for a/c charge/repair. Was
charged 1 week ago and now low on refrigerant.Partially
charged for testing and found cooling fans do not come on
with compressor.Now here's were it gets strange.If you turn
off the compressor the radiator... |
View |
|
2003 Dodge Pickup 5.7L Cuts out, Misfire, MIL Lamp on
This truck is a 2003 ram 3500 dually 5.7 hemi The truck
when hot and under med to heavy load will missfire
violently. It throws a p0300 multi miss immediately and
missfires on 6 out of 8 cylinders. the cylinders that are
missing are 1,2,3,5,7,8. 4 and 6 show z... Trouble codes: p0300 (multi cyl miss), p0394 (ckp sensor intermitttent). |
View |
|
2003 Dodge Pickup 5.9L drive shaft
we have a 2 wheel drive dodge that we replaced u joints in
for what we thought was the noise problem. it has a krinkle
noise like you would have with a dry needle bearing when
shifted from drive to reverse. it almost sounds like it is
coming from the middle of... |
View |
|
2006 Dodge Pickup 5.9L Poor Idle Quality, Cuts out, Stall, Misfire
Thanks for looking at this with me. I have a 06 Dodge 2500
here.. after the injectors were replaced at a shop across
town. customer complained of bad idle at startup. I have
found that when air heater circuit is running engine misses
badly. Im not a diesel tec... |
View |
|
1989 Jeep Wrangler 2.5L No Start
Vehicle towed in no start. Check fuel pressure ok 15 psi.
Varified no spark no injector pulse. Hooked up Modis no rpm
and injector pulse width while cranking. Test crank sensor
with scope perfect wave form replaced anyway still no rpm
or injector pulse. Ohm cr... |
View |
|
1996 Jeep Grand Cherokee 4.0L No Start, Stall
Vehicle originally came to us with a stalls/ won't restart
sometimes complaint. Checked for codes and found ignition
coil primary circuit code. Once we were able to duplicate
the problem, which usually happens after the vehicle is
warm, we found no ground cont... |
View |
|
1996 Jeep Grand Cherokee 4.0L Hesitation
Thanks in advance. This one is being a pain. This one will
not get out of its own way. Scanned computer and it had two
codes with no light on , P1762 and p1763 (transmission
solonoid voltage high and low. I dont know if this an old
code that has not been clear... |
View |
|
2006 Jeep Liberty 3.7L hvac
Hi All, have a strange one. This Liberty will have good
vent temps for the first 5-10 mins after initial start up
(50-55*F) then temps will climb almost to ambient.
Compressor cycles constantly unless low press. switch is
jumped. Suction line gets cold and swe... |
View |
|
1999 Chrysler Concorde 2.7L Cuts out, Stall
vehicle was never fixed. customer opted to leave with the vehicle as is. looking at the wiring harness as some suggested was helpful but lead no where. never tried oem parts used napa echlin parts that cleared the check engine light, but no the shutting off wh... Trouble codes: p1391 (camcrank intermittenly). |
12 |
|
1995 Dodge Stratus 2.5L od
The customer sent in the TCM and had it rebuilt. installed and no more limp mode or codes. tried different TCM while rebuilding original one and had same troubles. Not sure who he had rebuild TCM but so far I would have to say they fixed it. thanks to all who... |
12 |
|
1997 Dodge Grand Caravan 3.3L Starting
Thanks for the info. Replaced both bcm and ecm from dealer everything works fine. |
8 |
|
1999 Dodge Caravan 3.8L Excessive Emissions, Poor Idle Quality, Poor Fuel Economy
OK EVERY ONE I JUST NEED TO THANK ALL OF YOU FOR THE HELP THAT YOU ALL GAVE ME.ALL OF THE REPLIES WERE VERY GOOD.MOST OF THE REPLIES TOLD ME THAT IT WAS THE TIMING BETWEEN THE CRANK & CAM GEARS.OTHERS TOLD ME THE IDLE WAS TO LOW.BUT THE ONE THAT GAME ME THE ID... |
9 |
|
2002 Dodge Intrepid 2.7L Poor Idle Quality, Hesitation, MIL Lamp on
Thank you to all who replied ,Mike suggested that the EGR valve should not be grounded at all times, but on this system it is and the valve is supplied power by the computer to operate it. Sean suggested that the fuel trims and vaccume readings indicated a vac... Trouble codes: P0175 (Fuel sys rich bank 1), P0172 (Fuel sys rich bank 2). |
4 |
|
2003 Dodge Intrepid 3.5L L-R switch valve
I removed the valve body again, dissembled it, removed the L-R switch valve. We polished the valve ,reinstalled it,got the parts house to give us another solenoid pack, reassembled it. Did the quick learn and so far no problems. Thanks to all that replied. |
5 |
|
2003 Dodge Caravan 3.3L limp mode
Well after reviewing all of your input, that is greatly appreciated, i was able to find the problem. after the IPM was replaced i then got power to the TCM but still had same conditions. i aquired another caravan from the USPS fleet and swapped tcm's and VWALA... |
10 |
|
Prev
