|
1995 Acura NSX 3.0L MIL Lamp on
Hello all I got this NSX from one of my regular customers
he had it at the dealer and they replaced all six injectors
and an oxygen sensor. Less than one year ago and 2000 miles
ago I replaced plugs with oem spec NGK,s. On his way to my
shop to pick up one of ... Trouble codes: p1201 (misfire cylinder one), p1204 (misfire cylinder four), p1300 (random misfire). |
View |
|
2003 Hyundai Sonata 2.4L Poor Idle Quality, Hesitation, Misfire
Car came in with broken t belt/ valves. We replaced the
head ( reman. with cams/ lifters) and timing belt, it runs
bad at idle miss fires heavily, a bit smoother off idle,
idle vacuum is around 12 inches and goes to 15 inches at
2500 rpm. Compression seems hig... |
View |
|
1997 Kia Sephia 1.8L fuel
engine surge when pedal held at steady position don't no
probelm check map sensor show good. no dtc code |
View |
|
2005 Kia Optima 2.4L No Start, Stall
The car was towed with a no start condition. If you worried
with it a while it would start and run on two cylinders.(1
and 4) I scoped the control signal to the coils and tested
the power and ground to the coils and all looked good. The
waveform was identical ... Trouble codes: P0320 (ign failure sensor). |
View |
|
2003 Lexus GX470 4.7L Vehicle Skid Control
I need some help from some Lexus/Toyota pros. I am a tech
at a used car dealer. This Lexus came in for a slight
steering wheel shimmy at 55-70mph. It is not constant and
seems to change depending on road conditions. First we took
it to a goodyear to have the t... |
View |
|
2005 Lexus RX330 3.3L transfer case
is there any way to get transfer case out without pulling
whole engine assy like alldata says |
View |
|
1999 Mazda 626 2.5L timing belt
engine timing jump after few days. posibly cold start.
happens a third times |
View |
|
2001 Mazda 626 2.0L No Start
car came in as a no start,car will crank but no start.
checked for spark and had none. checked for fuel, none.
found the 30a fuse blown under hood for the egi/inj .
replaced fuse , as soon as i hit the key to crank it blew
fuse again. tried again but same resu... |
View |
|
1997 Mitsubishi Galant 2.4L Power Windows
All 4 Power windows do not work All fuses and wiring were
inspected and found to be OK. I have read some other
posting that talk about the ETACS. Is the ETACS the
problem? I have power at all for window swiches and I have
checked the motors and they all work a... |
View |
|
1991 Nissan Maxima 3.0L alt wiring
Greetings,
I received this vehicle with the alt wiring at the battery
fuse link cut and the fuse link missing. I am trying to
determine why someone would do this to make sure there
isn't a short or something going on.
Can anyone tell me what the current draw... |
View |
|
2000 Nissan Maxima 3.0L Hesitation, no power
MAXIMA CAME IN WITH EXTREME LACK OF POWER-ACTS LIKE
PLUGGED CAT.DID A BACKPRESSURE TEST AND FOUND IF YOU
INCREASE THROTTLE SLOWLY TO 3500RPM BACKPRESSURE STAYS
BELOW 1 PSI.IF YOU FLOORBOARD IT IT WILL NOT ACCELERATE
PAST ABOUT 2500/3000 RPM AND BACKPRESSURE IS... |
View |
|
2001 Nissan Pathfinder 3.5L No Start
Hi everyone, thank your time, After body work (front
end),the car drived to my shop,with check engine light on,
no gas padel feeling, only 10km /h less speed,check code
P0100 mass air flow sensor,P1320 ignition signal,P1136
crank sensor, after check and tying ... Trouble codes: P0100 (mass air flow sensor), P1320 (ignition signal), P1136 (crank postion sensor). |
View |
|
2003 Nissan Altima 3.5L Misfire, loss of power
Hi Gang, I would like to say thanks in advance on this.
This vehicle has a severe loss of power at higher engine
RPM (4200 and up) with a pronounced engine spark knock.
When it is colder it also has an induction backfire. O2
sensor voltage flat lines at 0V whe... |
View |
|
1994 Subaru Legacy 2.2L MIL Lamp on
Help Subaru Techs, I have a 94 legacy, came in with MIL on.
Code 35, Replaced purge solenoid. Cleared codes. MIL Wont
stop flashing. Cleared codes, ran memory check no codes,
cleared codes ran D check light starts flashing as it
should, turn off ignition & dis... Trouble codes: 35 (Evap Purge Solenoid). |
View |
|
1999 Subaru Forester 2.5L Clutch Pedal
Since we replaced the clutch ALL parts were Dakin OE Subaru
parts. The clutch pedal is soft and would occasionally stay
on the floor. The pedal pushes VERY easy. So I thought a
defective Pressure plate, so we replaced that same thing.
we used Dakin from WP whi... |
View |
|
2001 Subaru Forester 2.5L Noise
Customer brought vehicle incomplaining of a dull clunking
sound coming from the rear when going over bumps. To me it
sounds like a loose spare tire in the trunk, but the spare
is secure. I have put the vehicle in FWD mode and I think
the noise has gotten sligh... |
View |
|
2001 Toyota Tacoma 3.4L No Start
truck was run with low oil capacity and made some noise
and shut off.i added 2 1/2 qts of oil,and have no
start.checked fuel,have ign. at coil pack still no
start,battery fully charged as will. thanks for your help |
View |
|
2002 Toyota Camry 3.0L MIL Lamp on
First go around We Did smoke test found leak at vapor
canister , Replaced it , Its coming in tomorow for a
re-check , same code stored again , I will retest again ,
Check lines , and prior connections that were opened Am I
missing something , Do these have a p... Trouble codes: P0440 (Evap. system malfunction). |
View |
|
2003 Toyota Celica 1.8L Misfire, MIL Lamp on
get all cylinder misfires when cold,no lean codes ever Trouble codes: p0300 (multi cyl misfire), p0301 (cyl 1 misfire), p0302 (cyl 2 misfire), p0303, p0304 (cyl 4 misfire). |
View |
|
2005 Toyota Camry 2.4L Crank pulley
Car came back in after less than a month with exact same
problem. The outer ring where the serpentine belt rides has
completely separated from the inner portion. Has anyone
seen this happen? The belt looks fine, no alignment
problems are evident. |
View |
Prev
