Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 2, 2009
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Asian
Help Request Answers
1992 Acura Integra LS 1.8L MIL Lamp on VIN: JH4DA9459N
I need wiring diagram for ECM computer in & outs.
2003 Honda Civic Si 2.0L Excessive Emissions, Poor Idle Quality, Hesitation, Surge, Cuts out, Stall, Misfire, MIL Lamp on VIN: SHHEP33513
This vehicle came in barely running.Misfiring on all cylinders.Way too much fuel,plugs were black.Oxygen sesnsor comes and goes.When it is reading its 1.2 volts and long term and short fuel trims maxed fuel reduction.I have good spark to all cylinders.Replaced... Trouble codes: P0134, P0301, P0302, P0303, P0304, P1259
2001 Lexus LS430 4.3L key fob door locks windows except drivers door VIN: JTHBN30F01
this lexus is a very clean car looks like new. customer complaint is the key fob wont unlock the doors or pop the trunk. and factory alarm some times goes off when opening the car manually opon inspection the door locks wont work by either switch or the key fo...
2001 Nissan Sentra GXE 1.8L engine VIN: 3N1CB51D21
Engine stalls and starts up immediatly.

Fixes & Summaries for Asian
Fix/Summary Answers
1986 Nissan Maxima SE 3.0L Cuts out VIN: JN1HU11P7H
thanks everyone it was the distributor(crank sensor ).replaced it and came back to life. the maxima is back!
1997 Suzuki Sidekick JX 1.6L MIL Lamp on VIN: JS3TDO3V9V
thanks for all the feedback on this sidekick. I was able to swap most of the suspected parts from another sidekick from another aquantant, but no change of the code, it still come on. At this point, I would think most likely the egr passage need to be totall... Trouble codes: P0400.
1991 Toyota Pickup DLX 2.4L No Start VIN: JT4RN01P3M
Hello everyone, All responses were great and helpful. A number of people suggested wiring problems where the injector loom goes through the intake. Some suggested various component failures. After much testing, i found that the computer was bad (i think) When ...
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next