Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for February 10, 2009
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2004 Chrysler PT Cruiser Touring 2.4L Surge, MIL Lamp on VIN: 3C4FY58B94
Hi everyone . need some info on this pt , i have a code PO340 that will set on a road test and when it set the vehicle will surge at anything over 2300 rpm - fells like rev limiter kicking in -you can clear code and it will run perfectly for 5 to 15 miles befo... Trouble codes: P0340
1996 Dodge Ram 3500 Truck 5.9L crank sensor VIN: 1B6MF365XT
vehicle came in whith a bad engine. removed and replaced with a rebuilt engine. broke crank sensor removing and replaced with a napa sensor after engine was installed. crank sensor is rubbing fly wheel? napa sensor installed is # css601, should i be useing chr...
1997 Dodge Caravan SE 3.0L Poor Idle Quality, Stall VIN: 2B4GP4533V
came in with a stall at light,test drove has a rough idle,and only stalls when in gear and not all the time.feals like an open egr,hooked up scanner no codes,someone has been chasing this problem,looks to have newer plugs,wires,cap rotor,tps.pulled plugs look ...
2000 Dodge Ram 2500 Truck 5.9L No Start, Misfire VIN: 1B7KF2367Y
Help... This is my personal truck. I had a no-start six weeks ago and came down to a low fuel pressure problem(maybe 6psi) and thought the injection pump was gone also because of no fuel at injectors. Or very little. I put direct juice to Ipump and direct grou... Trouble codes: P1693
2001 Dodge Ram 1500 Van 5.2L Misfire, MIL Lamp on VIN: 2B6HB11Y81
Customer had car at Dodge dealership, was told it needed a valve job. Had misfire felt mostly at idle, and P0307 code. Brought van to us to re-check. Tried swapping spark plugs and wires, misfire stayed at #7. Injector was firing. Checked for the belly pan gas... Trouble codes: P0307
2001 Dodge Intrepid SE 2.7L No Start, Cuts out VIN: 2B3HD46R01
Greetings fellow Dodge techs, I have a 2001 Dodge Intrepid with a 2.7 engine that was replaced by another shop. This vehicle will run as long as the camshaft sensor is dis-connected, will not start when connected. The cam sensor has been replaced, the PCM ...
2003 Dodge Grand Caravan ES 3.8L No Start
checked all wires to and from pcm and fuse box found some corroded and repaired them, no luck started once for [...] then could never get it to start again spark yellowish not good blue spark only on cyl 2356 1 and 4 no spark , 2,3,5,6 occasional spark very... Trouble codes: P1391
2004 Dodge Stratus SXT 2.4L Misfire VIN: 1B3EL36X54
Here's what I have guys...I have a 2004 Dodge Stratus with the 2.4L "X" engine in my shop. The owner ran the original engine low in oil and ruined it. I got a used engine out a 2002 Chrysler Sebring with 37,850 miles on it. The salvage engine has been sitting ...
2004 Dodge Sprinter 3500 2.7L limp in VIN: WD1PD54454
Hi,we put a trans in this very hard working van and it lasted 4ok.So we got another one under warranty.Were not sure if these codes were in it before the install,but weve got po715 speed sensor,po672 glow plug,po730 gear ratio error now.With a generic scan too...
1992 Jeep Wrangler 2.5L Stall VIN: 2J4FY19PXN
We have a jeep here that has a o2 sensor that does not read correctly at times on the scanner. During the first ten minutes the engine is started, the o2 sensor will go from reading 0.1-0.9 volts to 4.5 volts and stay there. Engine still runs ok. Customer said... Trouble codes: 21 (o2 not switching)
1996 Jeep Grand Cherokee Laredo 4.0L par draw VIN: 1J4FX58S5T
i have a 200 mili amp draw on the battery if i pull the #7 fuse the draw goes away i have tracked this down to the bcm or the door modules if i unplug the door modules the bcm will go in sleep mode after about 45 min there is a tech bulliten on the bcm a...
1997 Jeep Grand Cherokee Limited 4.0L reverse VIN: 1J4JZ58S5V
no codes. came in needing trans rebuilt. no movement forward or reverse. front clutches welded together. rebuilt trans, rebuilt torque converter installed with trans rebuilding kit installed. took out for ride trans locks up when put into reverse.acts acts lik...

Fixes & Summaries for Chrysler
Fix/Summary Answers
1998 Chrysler Sebring JX 2.5L ignition VIN: 3C3EL45H7W
thanks for all the help i found the problem the single wire pin at the dist was pushed back into the connector i found it doing a contnuity test from the coil to the pcm thanks for the help
1996 Dodge Intrepid 3.3L No Start, Stall VIN: 1B3HD46TXT
We did end up taking apart the front engine, found there was play in the gears. Fixed the timing gear slop and when it was runing it stalled. So back to square one.I preformed a cam/crank sweep and found to be perfect now. When the car did stall I could see th... Trouble codes: P0320 (No Crank Ref at PCM).
2004 Dodge Durango SLT 5.7L cd VIN: X1D4HB58D4
Well i guess Chrysler strikes again... Going to send this one to dealer because we have no aftermarket way of dealing with this. I went through all the modules mith MODIS and tryed to find some kind of reprogram or functional test...nothing, TSB 08-004-04 soun...
2005 Dodge Neon SE 2.0L Misfire VIN: 1B3S56C55D
thanks for all the replies and thankyou ed did a leak down check on #4 cylinder exhaust valve leaking pulled head sent to machine shop installed car runs great must be a problem with these 2.0s car has only 58k keeped in great cond burnt 2 exhaust valves hope... Trouble codes: P0304.
2006 Dodge Caravan SE 2.4L crankshaft seal VIN: 1D4GP25BX6
Thanks to Chad [...] had seen this and replaced engines under warranty. This one is out of warranty, we replaced the thrust bearing and seals. Looks good at this point.
2000 Jeep Grand Cherokee Laredo 4.0L Poor Idle Quality VIN: 1J4GW48S6Y
All responders were right in the ballpark but one hit it dead on. The corrosion in the bulk connector on right side kick panel fixed it. Due to the multiplexing of the internal microprocessor the short to power caused the over 4 volt symptom. Thanks again and ... Trouble codes: P0123 (TPS always high), P1596 (Speed control switch always high).
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next